American Standard Colony 1.6 G.P.F. Toilet 2399 Istruzioni per l'installazione - Pagina 2

Sfoglia online o scarica il pdf Istruzioni per l'installazione per Arredamento per interni American Standard Colony 1.6 G.P.F. Toilet 2399. American Standard Colony 1.6 G.P.F. Toilet 2399 5. American standard renaissance el total toilet installation instructions

Stampa la pagina

BOLT CAP

CLOSET BOLT

WASHER

NUT

INSTALL TOILET

a. Position toilet squarely to wall and, with a rocking

motion, press bowl down fully on wax ring and flange.

Alternately tighten nuts until toilet is firmly seated on

floor.

CAUTION:

DO NOT OVERTIGHTEN NUTS

OR BASE MAY BE DAMAGED!

b. Install caps on washers. (If necessary, cut bolt height to

size before installing caps.)

c. Smooth off the bead of sealant around base. Remove

excess sealant.

INSTALL TOILET SEAT Install toilet seat in accordance with manufacturer's directions.

Before continuing, determine the type of water supply connecation you have from

the chart below and use the appropriate assembly parts required to properly

reconnect the water supply. DO NOT use plumber's putty to seal these fittings.

METAL/COPPER

METAL FLANGED

FLARED TUBING

TUBING

LOCK NUT

CONE

WASHER

COUPLING

NUT

WATER

SHUT-OFF

These parts must be used as

illustrated to insure water-tight

connection. Use of existing

coupling nut may result in

water leakage. Water supply

tube or pipe must extend at

least 1/2" inside threaded

shank of valve (does not apply

to flanged tubing).

CAUTION: DO NOT USE

CONE WASHER WITH

PLASTIC SUPPLY LINE.

CLOSET FLANGE

METAL SPIRAL

TUBING

LOCK NUT

EXISTING

WASHER

CONE

WASHER

EXISTING

COUPLING

NUT

WATER

SHUT-OFF

Use existing

Use existing spiral

coupling nut

cone washer.

and washer.

Fluidmaster cone

washer may not

seal completely on

spiral type supply

line.

CAUTION: Overtightening of

LOCK NUT or COUPLING NUT

could result in breakage and

potential flooding.

TANK MTG.

WASHER

INSTALL TANK

a. Install large rubber gasket over

threaded outlet on bottom of tank and

lower tank onto bowl so that tapered

end of gasket fits evenly into bowl

water inlet opening.

b. Insert tank mounting bolts and rubber

washers from inside tank, through

mounting holes, and secure with

metal washers and nuts.

c. With tank parallel to wall, alternately

tighten nuts until tank is snugged

down evenly against bowl surface.

DO NOT OVERTIGHTEN NUTS MORE

THAN REQUIRED FOR A SNUG FIT!

VINYL/BRAIDED

CONNECTOR

LOCK NUT

COUPLING

NUT

WATER

SHUT-OFF

Captive cone

washers already

included. No

additional washers

needed.

- 2 -

RUBBER

WASHER

RUBBER

GASKET

BOLTS

NUT

CAUTION:

With correct washers in place

(see Step 9a), tighten

COUPLING NUT 1/4 turn beyond

hand tight. DO NOT

OVERTIGHTEN.

7301186- 1 00 Re v. B