DOMUS LINE ATOM SP Manuale di installazione - Pagina 5

Sfoglia online o scarica il pdf Manuale di installazione per Apparecchio di illuminazione DOMUS LINE ATOM SP. DOMUS LINE ATOM SP 14.

INSTALLATION MANUAL

WARNING

Safety is guaranteed if these instructions are followed and

therefore they must be kept. Installation may require the

involvement of qualified personnel. Before proceeding with

installation of the device, ensure that the environmental

conditions are in conformity with and suitable for the

characteristics of the product. Before any operation on the

device disconnect mains power.

FLUSH INSTALLATION ON WOOD PANELS

ATOM devices can be flush mounted either on a pass-through

hole or on a closed-end hole in wood panels.

The installation can be carried out with the light power supply

cable in both an axial or radial position with respect to the

installation surface. In the event of a specific requirement a

power wire exit hole can nevertheless be drilled in other

positions as long as it does not compromise the integrity of the

wire and/or the connector installed on it.

- To flush mount the device, bore a ø 57mm hole ≥ 8mm deep on

the installation surface and then, if necessary, bore a ø ≥ 8mm

exit hole for the power supply cable as illustrated in figure 1.

- Insert the power supply cable (A) into the hole and then install

the light (B), applying light pressure until it is completely fitted

as illustrated in figure 2.

FLUSH INSTALLATION ON METAL SURFACES

ATOM devices can be flush mounted on 0.7 mm thick (min.)

metal surfaces and on a ø 57 mm hole as illustrated in figure 3.

- The light must be anchored to the metallic bracket by inserting

first one spring and then the other, applying slight pressure until

completely fitted as illustrated in figure 4.

SURFACE INSTALLATION

ATOM can be surface mounted with the aid of specific supports.