American Standard 6030ST3 Istruzioni per l'installazione - Pagina 2
Sfoglia online o scarica il pdf Istruzioni per l'installazione per Vasche da bagno American Standard 6030ST3. American Standard 6030ST3 4. Seated shower base
Stampa la pagina
GENERAL INSTALLATION INFORMATION ...
1. SHOWER BASE MAY ONLY BE INSTALLED IN A RECESS TYPE INSTALLATION.
2. THIS SHOWER BASE IS NOT SELF-SUPPORTING AND MUST BE SUPPORTED ALONG ITS
ENTIRE BOTTOM WITH MORTAR OR GROUT. STRINGERS WILL HELP LEVEL SHOWER BASE,
BUT WILL NOT PROVIDE ADEQUATE SUPPORT.
3. TAKE EXTRA CARE WHEN DRIVING NAILS OR SCREWS TO AVOID DAMAGING THE SHOWER BASE.
1
INSTALLATION AND FRAMING INSTRUCTIONS:
A.) Locate studs as required. Ensure roughing-in dimensions are proper, plumb, and square. It is strongly recommended that
an additional opening be provided for access to the drain components.
If using the 6030SW Wall Surround,
adjust the studs according to the
wall instructions.
B.) As shown in ILL. 2, mark the position of the underside of the deck by tracing a line onto the studs at the height indicated,
using a level or other suitable straight edge.
C.) With the top of the stringer touching the traced line, attach the stringer to the studs.
D.) Install drain components to the shower base following the manufacturer's instructions. See the roughing-in drawing for
suggested opening size and location dimensions.
ILLUSTRATION 1
ILLUSTRATION 2
19-3/4"
(502mm)
2
Each alcove
stud must be
plumb and
square.
28-1/2"
(724mm)
755173-100