American Standard Acrylux Builder Series Bathtubs 6030Y1.202.XXX Istruzioni per l'installazione - Pagina 2

Sfoglia online o scarica il pdf Istruzioni per l'installazione per Vasche da bagno American Standard Acrylux Builder Series Bathtubs 6030Y1.202.XXX. American Standard Acrylux Builder Series Bathtubs 6030Y1.202.XXX 3. American standard acrylux builder series bathtubs installation instructions

Stampa la pagina

INSTALLATION INSTRUCTIONS

STEP 1. PREPARING ALCOVE

• Strip to bare studs.

• Alcove studs should be constructed as shown above.

• Floor must be clean, smooth, and level (check with level). Sub

floor must be installed. Do not install tub on open floor joists.

• Cut hole in sub floor as shown on page 1 to accommodate drain.

STEP 2. INSTALLING TUB

• Trial fit tub in prepared alcove. With tub sitting flat on floor, check

with level on top of tub. Tub should be level from front-to-back

and side-to-side (Fig 1).

• A floor leveling compound (smooth mortar) or a similar

quick-setting compound specifically made for leveling floors may

be used to fully support and level base.

• After tub is leveled, if alcove is larger than tub, shim between tub

and studs to create a tight fit. Screw tub flange to studs (Fig. 2).

CLEANING

• Do not use any abrasive cleaners or metal scrapers.

• If drywall mud or plaster gets on your shower, it may be carefully removed with a wooden scraper made from

a piece of scrap wood.

• Adhesive may be removed with mineral spirits.

• Ideal cleaners are Soft Scrub Gel

WARNING:

Some cleaning products are not suitable for use. Read all labels carefully.

DO NOT USE if they say "not suitable for use with ABS, acrylic, or polystyrene.

or Comet Gel

- 2-

FIGURE 1. Check to assure tub is level.

FIGURE 2. If necessary, shim between tub and studs for

tight fit and screw to each stud.

75428 1 -1 0 0 Re v. A