American Standard Colony 2740 Series Istruzioni per l'installazione - Pagina 2
Sfoglia online o scarica il pdf Istruzioni per l'installazione per Vasche da bagno American Standard Colony 2740 Series. American Standard Colony 2740 Series 4. 5 x 30 afr whirlpool/bathing pool, integral apron with removable access panel, for above-floor rough installation, high gloss acrylic, shown less all fittings
Anche per American Standard Colony 2740 Series: Manuale di istruzioni per il funzionamento e la manutenzione (10 pagine)
Stampa la pagina
INSTALLATION AND FRAMING INSTRUCTIONS
Locate studs as required. Ensure roughing-in dimensions are proper, plumb and square. Access to Pump/Motor may be
made through the access opening in the apron panel. It is strongly recommended that an additional opening be provided
for access to the drain components.
NOTE: The apron may be used as the primary access opening.
1. As shown in Fig. 1, mark the position of the underside of the deck by tracing a line onto the studs at the height indicated,
using a level or other suitable straight edge.
2. With the top of the stringer touching the traced line, attach the stringer to the studs.
3. Install drain components to the whirlpool or bath following the manufacturers instructions.
4. THIS BATH MUST BE SUPPORTED ALONG ITS ENTIRE BOTTOM. We recommend the use of mortar as bedding
material (sand is not recommended). Apply enough bedding to support the complete bottom of the bath. After the
bedding has been poured, and before it sets, position whirlpool or bath within recess until the rim is leveled against the
leveling stringers (see "Typical Recess Installation") shown below. The rim of the bath MUST NOT support weight.
Allow the bedding material to completey harden before applying weight to the rim or bottom of the bath. Any finish
material such as tile or wall board must be self-supporting if it contacts the deck of the bath.
FIG. 1
19
(483mm)
TYPICAL RECESS INSTALLATION
19
(483mm)
60-3/16
(1529mm)
752562-100 Rev. H
LEVELING
STRINGERS
34 Typ.
(864mm)
SUGGESTED WHIRLPOOL/BATH INSTALLATION METHOD
Waterproof Dry Wall
or Cement Board
Finished Wall
Sealant
Tub
Leveling Stringer
1 x 3 (25 x 76mm) WOOD
SECURE THE BATH TO THE STUDS AS SHOWN FOR
WOOD OR STEEL STUD CONSTRUCTION.
2
Stud
(Wood or Steel)