American Standard Ellisse 2711.XXXW Series Istruzioni per l'installazione - Pagina 2

Sfoglia online o scarica il pdf Istruzioni per l'installazione per Vasche da bagno American Standard Ellisse 2711.XXXW Series. American Standard Ellisse 2711.XXXW Series 4. 6' x 48" whirlpool, high gloss acrylic shown less all fittings

Stampa la pagina
INSTALLATION AND FRAMING INSTRUCTIONS
The variety of installations possible for this whirlpool may require framing procedures other than those shown. Locate studs
as required. Ensure roughing-in dimensions are proper, plumb and square. Provisions must be made in all installations for an
access opening for servicing the pump and controls. It is strongly recommended that an additional opening be provided for
access to the drain components.
NOTE: The apron should not be used as the primary access opening.
1. Position the whirlpool into the installation opening and level the deck, shimming the integral support feet as necessary.
Mark the final position of the underside of the deck by tracing a line on to the studs (see Figure 1).
2. Remove the whirlpool and attach a 2 x 4 stringer to the studs, with the top of the stringer touching the traced line.
3. Install drain components to the whirlpool following the manufacturers instructions. Before replacing your whirlpool for final
installation, be certain that an opening has been provided in the sub-floor for the drain. See the roughing-in drawing for
suggested opening size and location dimensions.
4. Replace whirlpool and re-shim the integral support feet, shimming the entire length of the support feet. Secure the shims
using construction adhesive, silicone, mortar or equivalent materials. While not a necessity, the use of a foundation base
consisting of cement (e.g. Sakrete), mortar, or grout will help provide a solid and secure installation.
TYPICAL RECESS INSTALLATION
495mm
(19-1/2)
1832mm
(72-1/8)
TILE
TILE BEAD
STRIP
SEALANT
BATH
UNLESS AN ACCESS OPENING OF
ADHESIVE
AT LEAST 12" X 24" (305 X 610MM)
IS PROVIDED, WARRANTY SERVICE
LEVELING
WILL NOT BE PERFORMED.
STRINGER
752296-100 REV. H
495mm
(19-1/2)
L E V EL I NG
S TRI N GE R S
610 mm
FIG. 1
TYPICAL PIER TYPE INSTALLATION
AS DESI RED
495mm
(19-1/2)
305mm
(12)
LEVELING
SURFACE
(24)
(2)
1181mm
(46-1/2)
AS
DESIRED
WATERPROOF
SEALANT
ACCESS PANEL
BATH
UNLESS AN ACCESS OPENING OF
AT LEAST 12" X 24" (305 X 610MM)
IS PROVIDED, WARRANTY SERVICE
WILL NOT BE PERFORMED.
1791mm
(70-1/2)
CUTOUT
305mm
(12)
610mm
(24)