American Standard Princeton 2396.202.IBS Istruzioni per l'installazione - Pagina 3
Sfoglia online o scarica il pdf Istruzioni per l'installazione per Vasche da bagno American Standard Princeton 2396.202.IBS. American Standard Princeton 2396.202.IBS 4. Bath with integral overflow
Stampa la pagina
3
INSTALLATION
The tub is provided with an integral base for easier installation. Position the bath on the floor and slide into place until
the tub is resting on the rear stringer. The base does not need to contact the floor for proper installation. The base on
the 2396 and 2397 models is raised above the floor to facilitate drain installation. Check level, front to back and side to
side. Also check drain clearance hole in sub floor. To secure the tub to wood studs, use roofing nails immediately above
the flange of the tub. To secure the tub to steel studs, use drywall screws and flat washers. (See Step 4)
Caution: Take Extra Care When Driving Nails or Screws To Avoid Damaging The Tub.
The tile or similar finished floor will be butted against the bottom of the tub apron also holding the tub in place.
NOTE: Warranty will be voided if the drain is installed after the tub has been set in place.
4
Below is shown typical cross sections of the tub rim showing typical wall constructions.
WOOD STUDS
STUD
SHIM
DRY WALL
TILE
ROOFING NAIL
SEALANT
TUB
NAIL
OR
DRYWALL
SCREW
EVERY STUD
51 x 102mm (2 x 4) WOOD
STRINGER FULL LENGTH
UNDERLAYMENT
FINISHED TILE FLOOR
SUB FLOOR
STEEL
STUD
SHIM
DRY WALL
TILE
SEALANT
TUB
- 3 -
STEEL STUDS
WASHER
4"
DRYWALL
SCREW
791175-400 Rev. M