Da-Lite Contour Electrol Libro di istruzioni - Pagina 3
Sfoglia online o scarica il pdf Libro di istruzioni per Schermo di proiezione Da-Lite Contour Electrol. Da-Lite Contour Electrol 9. Installer friendly features
Anche per Da-Lite Contour Electrol: Libro di istruzioni (13 pagine), Manuale dell'installatore (2 pagine), Libro di istruzioni (4 pagine), Libro di istruzioni (8 pagine), Libro di istruzioni (8 pagine)
Stampa la pagina
INSTALLATION
Carefully unpack screen and remove outer wrapping from
case.
Remove the black tape and rubber bands from the slat bar
after the case has been installed.
There are three ways to install the Contour
Mount, Ceiling Mount, or Ceiling Hook. Procedures for each
method are as follows:
Wall Mount
1. Secure the wall mount bracket to the wall at the
desired height. Bracket should be fastened to wall
studs or some reinforcement within the wall. Concrete
or brick walls require special fasteners and anchors.
2. Make sure the bracket is level. See figure 1 for
reference dimensions.
3. Keep in mind you will need at least 2-3/8" between the
ceiling and the top of the wall mount bracket to be
able to position the case on the bracket.
4. Mount the screen case on the wall bracket as shown
in figure 1. Be sure the case is fully seated on the
bracket. Tighten the stop screws against the wall
bracket.
Ceiling Mount
1. Do not remove the wall mount bracket, even if you are
not using it for mounting. This provides structural
stability to the case.
2. Be sure the ceiling has adequate reinforcement to
attach the screen brackets.
3. The top of the screen case has two channels with
threaded nuts that slide the length of the case. Attach
two ceiling mount brackets to the screen case as
shown in figure 2. Mount cannot be more than 12"
from end of case.
4. Hold the screen case up to the ceiling and mark the
hole locations. The brackets have a set of front holes
and a set of rear holes. It is best to use at least one
hole in each set.
Ceiling Hook
1. Do not remove the wall mount bracket, even if you are
not using it for mounting. This provides structural
stability to the case.
2. Be sure the ceiling has adequate reinforcement to
attach a hook anchor.
3. The top of the screen case has two channels with
threaded nuts that slide the length of the case. Attach
ceiling hook brackets as provided to the screen case
as shown in figure 3.
4. The brackets can be attached anywhere within 12" of
the end of the case.
5. Attach an S-hook or similar fastener to the hole in the
bracket.
Electrol
: Wall
®
®
2
5-11/16"
6-3/8"
SToP SCREW
FIGURE 1
FIGURE 2
FIGURE 3
2-5/16"
CASE
2-9/16"
HooK
WAll
MounT
BRACKET
1/4 x 5/8" flAT
HEAD SCREW
CEIlIng
MounT
BRACKET
CEIlIng HooK BRACKET
1/4 x 5/8" flAT
HEAD SCREW