Da-Lite Polacoat Da-Plex Semi-Rigid Libro di istruzioni - Pagina 7
Sfoglia online o scarica il pdf Libro di istruzioni per Schermo di proiezione Da-Lite Polacoat Da-Plex Semi-Rigid. Da-Lite Polacoat Da-Plex Semi-Rigid 12.
Stampa la pagina
Installation (continued)
9. At the unrolled screen surface, peel back the protective paper
approximately 3/4" on all sides. This will allow the frame to be
attached easily to the screen surface.
NOTE: Do not remove the protective paper completely. This
will be done at the end of the screen installation in order to
protect the surface during the hanging process.
10. Center the first rubber gasket on the screen surface edge and
press it into place starting at one end. Repeat this step for the
three remaining sides of the screen.
Hoisting Brackets
Frame
Section
Pre-Attached
Hoisting Bracket
Hoisting Bracket
11. Place the frame sections around the screen surface. Attach to
frame over the rubber gasket with set screws facing upwards.
Use a rubber mallet to gently tap the screen frame into place
if needed (See Figure 5)
12. Starting from the center on each side, tighten all set screws
on all four sides of the frame using the 1/8" hex key.
Approximately two threads should be visible on each set
screw when properly tightened.
13. Place the hoisting bracket in the center of the top and bottom
sections of the screen frame. Attach to frame using the
provided cap screws and a 3/16" hex key.
Rubber Gasket
Figure 5
Hoisting Bracket
Frame
Section
(Projector Side)
Rubber Gasket
Cap
Screw
Screen
Set Screw
7