American Standard Champion 4 MAX Right Height 231BA Series Manuale di istruzioni per l'installazione - Pagina 7

Sfoglia online o scarica il pdf Manuale di istruzioni per l'installazione per Servizi igienici American Standard Champion 4 MAX Right Height 231BA Series. American Standard Champion 4 MAX Right Height 231BA Series 8. 2-piece toilet

Stampa la pagina

American Standard Champion 4 MAX Right Height 231BA Series Manuale di istruzioni per l'installazione

TROUBLE SHOOTING FLUSH VALVE SEAL LEAKS :

Lift piston up by pulling up on the lift chain, inspect seal for visible

distortion and presence of debris on sealing surface with finger.

SEAL REPLACEMENT:

1. Turn off water supply and flush toilet to empty tank.

2. Disconnect Chain from Trip Lever by removing Hair Pin Cotter

and Clevis Pin.

3. Partially lift and support piston bottom with one hand.

4. Remove thumbscrew by turning counter-clockwise.

5. Remove piston top and gasket.

6. Replace gasket with new gasket.

7. Reverse procedure, turn thumbscrew until 2 clicks are felt.

HAIR PIN

COTTER

NOTE: DO NOT ADD ANY FOREIGN MATERIALS TO THE SEALING SURFACE.

CARE AND CLEANING

When cleaning your toilet, wash it with mild, soapy water, rinse thoroughly with clear water and dry with a soft cloth.

WARNING:

Do not use in-tank cleaners. These products can seriously damage fittings in the tank.

This damage can cause leakage and property damage.

American Standard shall not be responsible or liable for any damage caused by the use of in-tank cleaners.

LIFT ARM

FIRST

IMPORTANT: Always clear

sand and rust from system.

• Make sure water supply is off.

Remove valve TOP by lifting

arm and rotating top and arm

1/8 turn counterclockwise,

pressing down slightly on cap.

Always use quality Fluidmaster repair parts when maintaining your Fluidmaster products. Fluidmaster

shall not be responsible or liable for any damages caused by products used with Fluidmaster valves

that were not manufactured by Fluidmaster, Inc.

THUMBSCREW

PISTON TOP

GASKET

PISTON BOTTOM

• While holding a

container over the

uncapped VALVE to

prevent splashing, turn

water supply on and

off a few times. Leave

water supply off.

11a

REFILL TUBE REPLACEMENT:

• Replace TOP by engaging

lugs and rotating 1/8 turn

clockwise. MAKE CERTAIN

TIP IS TURNED TO THE

LOCKED POSITION. VALVE

MAY NOT TURN ON IF TOP

IS NOT FULLY TURNED TO

THE LOCKED POSITION.

- 3 -

Locate bottom portion of

hose clip to vent tube at

location as shown.

TROUBLESHOOTING

IF FILL VALVE SHUTS OFF BUT CONTINUES TO

LEAK SLOWLY, repeat Step 13.

IF FILL VALVE TURNS OFF AND ON DURING

PERIODS OF NON-USE, it is a signal you are

wasting water because:

• The end of the refill tube is inserted into overflow

pipe, below water level in tank. Attach refill tube to

overflow pipe using "S" clip provided.

• The flush valve is leaking because it's worn, dirty

or misaligned.

IF FILL VALVE WON'T TURN ON OR SHUT OFF

or REFILL OF TANK WATER IS SLOW after

valve has been in use for some time, Fluidmaster

Model 242 Replacement Seal may be needed.

Go to our website at www.fluidmaster.com for