Da-Lite TENSIONED CONTOUR ELECTROL Libro di istruzioni - Pagina 8
Sfoglia online o scarica il pdf Libro di istruzioni per Accessori per proiettori Da-Lite TENSIONED CONTOUR ELECTROL. Da-Lite TENSIONED CONTOUR ELECTROL 13. Installer friendly features
Anche per Da-Lite TENSIONED CONTOUR ELECTROL: Libro di istruzioni (13 pagine), Libro di istruzioni (9 pagine), Manuale dell'installatore (2 pagine), Manuale di istruzioni (9 pagine)
Stampa la pagina
Optional Built-In Video Projector Interface
CAUTION: The projector must be turned off before
connecting the trigger wires to the projector. Failure to
do so may damage the controller.
ATTENTION: Le projecteur doit être éteint avant de
brancher les fils de déclenchement à celui-ci. Tout
manquement à cette instruction pourrait endommager le
contrôleur.
Use 2-conductor 18–24 gauge wire to extend the low voltage
connection from the projector's 5 or 12-volt screen trigger output
to the length required to reach the VPI.
NOTE: When extending the low voltage connection from the
projector's screen trigger output polarity does not matter. The
red and black wires from the VPI are interchangeable.
8
RJ-22 Jack
(Connection to
Wall Switch)
VPI Trigger
Module
Black
Red
5/12 Volt
Screen Trigger
on Projector
IMPORTANT NOTE: The wall switch is REQUIRED to make any
limit switch adjustments, EVEN if a third party control system is
used. Therefore, it is advised to wire the switch or provide a
3-conductor connection that is accessible.
3-conductor 20–24 gauge wire can be used in place of the
supplied RJ-14 cable to connect the wall switch. Connect the BUS
U P
terminals on the wall switch to the corresponding BUS terminals
on the splitter board.
S T O
P
See 120V or 220V wiring diagram from complete wiring
D O
W N
instructions.
RJ-22
Jack (QEYE)