SCREEN ADJUSTMENT
Surface travel is stopped automatically in the fully opened and closed positions by limit switches that are properly
adjusted at DA-LITE. Should it be necessary to adjust for more or less picture drop (viewing area), proceed in the
following manner:
NOTE: Use a screwdriver or allen wrench to make adjustments.
MORE SCREEN DROP
1. Place operating switch in "down" position.
2. When the screen stops, turn the white "down" limit knob (Fig. 3) one-quarter turn counter-clockwise. Test by raising
picture surface approximately two feet, then lower again. Repeat until desired picture surface position is attained.
LESS SCREEN DROP
1. Raise picture surface approximately two feet above desired level.
2. Place operating switch in "off" position.
3. Turn the white "down" limit knob one-quarter turn clockwise. Test by raising picture surface approximately two feet,
then lower again. Repeat until desired picture surface is attained.
NOTE: The yellow UP adjusting knob is located at motor end and is accessible through the fabric opening. The white DOWN
adjusting knob is located at motor end and is accessible through the fabric opening.
!
CAUTION! When adjusting and testing, be prepared to stop screen quickly as serious damage may occur.
COSMOPOLITAN ELECTROL INSTALLATION
3/4" DIAMETER HOLE FOR
WALL INSTALLATION
MOTOR END
4"
Overall length A=fabric width + 8".
Length B is the distance between wall mounting holes
at back of end caps and is the fabric width + 6-1/2".
A
B
FABRIC HEIGHT x WIDTH AS ORDERED,
UP TO 12 FEET x 12 FEET.
FIGURE 2
4"
13/32"
5-7/8"
2
4-5/8"
1-7/8"
3/8" DIAMETER FOR
CEILING INSTALLATION
ENCLOSURE COVER
7/8" DIAMETER OPENING
FOR ELECTRICAL FITTINGS
PICTURE SURFACE
1"
15/16"
Stampa la pagina