Canon Color imageCLASS MF8280Cw Manuale delle impostazioni - Pagina 5
Sfoglia online o scarica il pdf Manuale delle impostazioni per Stampante All in One Canon Color imageCLASS MF8280Cw. Canon Color imageCLASS MF8280Cw 20. Wireless lan
Anche per Canon Color imageCLASS MF8280Cw: Manuale delle impostazioni (25 pagine), Manuale introduttivo (37 pagine), Manuale rapido (4 pagine), Come iniziare (36 pagine)
Stampa la pagina
Setting Wireless LAN
Push Button Mode
1
Press
.
2
Select <Network Settings>, and then press [OK] .
3
Select <Wireless LAN Settings>, and then press
[OK] .
4
Press [OK] .
If <Do you want to enable the wireless LAN?> is
displayed, press [▲] to highlight <Yes>, and then press
[OK] .
5
Select <WPS Push Button Mode>, and then
press [OK]
6
Select <Yes>, and then press [OK] .
7
You should press the WPS button within 2
minutes after you select <Yes> in step 6 . Press
and hold* the button until the WPS lamp lights or
blinks .
* The time that you should hold the button may vary depending
on the wireless router you are using .
Wait approximately 2 minutes after the connection.
IP address is set during this period of time .
When an error message appears:
Press [OK] to close the screen, check whether or not
the WPS function of the wireless router is correctly set,
and then retry the settings .If the access point cannot be
detected even after retrying, see the following .
e-Manual "When an Error Message Appears"
When checking the network connection:
You can check if the machine is properly connected to
the network using a computer that connected to the same
network .
"Checking That the Wireless LAN Setting is Completed"
(P .6)
To set IP address manually:
e-Manual "Setting IP Addresses"
Setting the Access Point Manually
If you do not know SSID (access point name) and network
key that you are using, check a label attached on the
wireless router or use Canon MF/LBP Wireless Setup
Assistant (See "Checking SSID or Network Key for a
Wireless Router" (P .7) to know your SSID and network key .)
Write down the SSID and network key below, for reference .
SSID
It is sometimes written as name of network, or name of
access point . If there are multiple SSIDs, please write
down all .
Network Key
It is sometimes written as PIN, WEP key, WPA/WPA2
passphrase, PSK or preshared key .
1
Press
.
2
Select <Network Settings>, and then press [OK] .
3
Select <Wireless LAN Settings>, and then press
[OK] .
4
Press [OK] .
If <Do you want to enable the wireless LAN?> is
displayed, press [▲] to highlight <Yes>, and then press
[OK] .
5
Select <SSID Settings>, and then press [OK] .
6
Select <Select Access Point>, and then press
[OK] .
7
Select the access point that you wrote down, and
then press [OK] .
If multiple matched SSIDs are displayed, select the ID
that is listed first (the one with the strongest signal) .
Proceed to the next page
5
En