Ekinex EK-GO1-DL Manuale di avvio rapido - Pagina 3

Sfoglia online o scarica il pdf Manuale di avvio rapido per Dimmer Ekinex EK-GO1-DL. Ekinex EK-GO1-DL 4. Dali 4-channel 230 vac dimmer

Stampa la pagina

INSTALLATION TECHNICAL NOTES

• Installation and maintenance must be

performed only if the power supply has

been turned off.

• Installation and maintenance must only

be performed by qualified personnel in

compliance with current regulations.

• The product must be installed inside

an electrical panel protected from over-

voltages.

• The product must be protected by a sui-

tably sized fuse.

• The product must be protected by a sui-

tably sized magnetothermic switch.

• The product must be installed in a verti-

cal position with the front / label facing

the front or in a horizontal position with

the front / label facing upwards. Other

product installation positions are not al-

lowed. The bottom position with the front

panel / label facing down is not allowed.

• Use in thermally harsh environments

could limit the output power.

• Keep 230V circuits (LV) and non-SELV

circuits separate from SELV circuits with

very low safety voltage

AC Dimmer

EK-GO1-DL

Input: 230V ~ 50Hz

Output: 230V ~

Load: 4x 200W max

FUSE

230 Vac

50-60 Hz

Installation scheme

Configuration and commissioning

Configuration and commissioning activities of the device

must be carried out according to the design of the building

automation system done by a qualified planner.

For commissioning the device the following activities are

required:

• make the electrical connections as indicated above;

• power up the bus;

• carry out the device addressing, which can be done in

two ways:

simplified method: by connecting one ballast at a

time, each one will get the address progressively

from 0 to 63;

DALI

DA DA

DALI IN

DALI OUT

OUTPUT

BUS PWR

random address allocation: by connecting all the bal-

lasts at the same time, each one will get a random

address.

Subsequently, the address configuration can be changed

by using an application for parameterization, for example

by downloading the ekinex CGEKBG1TP software to your

PC which allows to:

• configure the DALI system and define its parameters;

• set the DALI luminaires (groups, scenarios, IDs, etc.);

• test the communication on the DALI bus;

• update the device.

The software can be downloaded from www.ekinex.com

website and its use is described in the application manual

of the ekinex EK-BG1-TP DALI Gateway. The software

requires Microsoft Windows (7 and later).

Note. In order to install and use the CGEKBG1TP

configuration software, it could be necessary the

installation of .NET Framework 4, which can bee

freely downloaded from Microsoft.com website.

DALI channel maps

Type of load: single color up to 4 loads

Address

Function

Dimmer 1

Dimmer 2

Dimmer 3

Dimmer 4

Signaling LEDs

On the front of the device there are 6 signaling LEDs:

• 1-2-3-4 for each channel

• BUS for traffic indication on the DALI bus

• PWR to indicate that the device is powered on

If the BUS is not supplied or there is a BUS error, the rela-

tive signaling LED flashes quickly (2 pulses per second).

If the BUS is supplied but there is a BUS error, the relative

signaling LED flashes slowly (1 pulses per second).

If the BUS is connected and it is working properly, the

LED remains on steady.

Dimmer map

Dimmer (Intensity Value) 0 ... 254