Air Creation GTE Trek 503 Manuale di istruzioni e manutenzione - Pagina 13

Sfoglia online o scarica il pdf Manuale di istruzioni e manutenzione per Aerei Air Creation GTE Trek 503. Air Creation GTE Trek 503 18. Trikes

Stampa la pagina
Every 10 hours of flight time :
Check trike, engine and propeller nuts.
•
Check the exhaust system, the rubber mounts and the springs.
•
Check air filter condition and attachments.
•
Check water pipes condition, make sure air intake of radiator is well clear for water-cooled
•
engines.
Check fuel filter and fuel primer pump condition/ cleanliness, attachments and ensure there
•
are no leaks on fuel hoses.
Check propeller condition.
•
Every 50 hours of flight time :
Check the engine rubber mounts.
•
Change the 2 front wheel shock absorbers.
•
Check condition of the manual starter cord.
•
Check the beams where the engine is mounted and around the swivel joint for cracks or
•
movement.
Check seams on welded assemblies and mounting holes for movement (engine support,
•
front forks, hooking frame point, beam swivel joint, radiator mount.).
Check rear shock absorber air pressure by exerting a lateral traction on the upper beam.
•
Insufficient pressure will cause the trike suspension units to subside under load or lean
excessively during turning on the ground or in cross-winds. Fill to 40 Bar using a special
hand-pump where required (or see your dealer).
•
Every 25 landings maximum,
absorber »set. The difference (sets at full extension) should not exceed 2mm. If not, you
should arrange for an overhaul. Moreover the overhaul of the "shock absorber" set has to be
made
every 250 take-off or every 3 years of use.
Check condition and running of throttle and brake cables.
•
Clean air filter.
•
Every 100 flight hours :
Check all bolts involved in frequent mounting/dismounting operations (hang-point, front
•
strut, etc.), engine and propeller mounting bolts.
Check tires, rims, wheel bearings front fork and wheel axles.
•
Check engine support, hang point, undercarriage struts and links, wheel shafts and seat
•
seams.
Check upper and lower mounting connections of front tube. Remove the upper and lower
•
Nylon bases and inspect the tube where it enters the hole for ovalization or cracks.
Tél. : 33 (0) 4 75 93 66 66 - Fax : 33 (0) 4 75 35 04 03 - Internet : www.aircreation.fr – [email protected]
check the length of the sliding tubes of the « shock
GDMANTREK503582-1G
AIR CREATION Aérodrome de Lanas - 07200 AUBENAS - France
Version 0010
PAGE : 13