American Time SiteSynq IQ Manuale di installazione e funzionamento - Pagina 9
Sfoglia online o scarica il pdf Manuale di installazione e funzionamento per Orologio American Time SiteSynq IQ. American Time SiteSynq IQ 19. Wireless digital clocks
Wireless Digital Clocks Owner's Manual
Wireless Digital Clocks Owner's Manual
Up Counter Elapsed Time Operation
Once the desired preset value has been set, the unit is now ready to function as an UP count elapsed timer.
Be sure the SET/RUN switch is in the RUN position.
Set the UP/DOWN/CLOCK switch to the UP position.
Press RESET to display 00:00:00.
Press the START/STOP switch to begin counting elapsed time.
Press the START/STOP switch again to stop and hold the count.
Press the START/STOP switch again to resume elapsed time counting.
To start over press RESET to display 00:00:00 again.
When the timer reaches the preset value, it will sound the audible alarm for 2 seconds and hold the time count.
During an UP count elapsed time operation, you can display any of the other time functions using the UP/DOWN/
CLOCK switch as desired.
Setting the Down Counter Preset Time
If you are using the clock as a DOWN counting elapsed timer, you will need to set a preset time to count DOWN from.
In this mode, the alarm and hold will occur at 00:00:00.
Set the UP/DOWN/CLOCK switch to the DOWN position.
Set the SET/RUN switch to the SET position. The hours digits will be flashing.
Using the INCREMENT switch, set the desired hours for the preset time, then press ENTER. The minutes digits
will now be flashing.
Using the INCREMENT switch, set the desired minutes for the preset time, then press ENTER. The seconds
digits will then be flashing.
Using the INCREMENT switch, set the desired seconds for the preset time, then press ENTER. The display will
then flash
.
donE
Set the SET/RUN switch back to the RUN position.
Down Counter Elapsed Time Operation
Once the desired preset value has been set, the unit is now ready to function as a DOWN count elapsed timer.
Set the UP/DOWN/CLOCK switch to the DOWN position.
Be sure the SET/RUN switch is in the RUN position.
Press RESET to display the preset value which was set previously.
Press the START/STOP switch to begin counting down elapsed time.
Press the START/STOP switch again to stop and hold the count.
Press the START/STOP switch again to resume elapsed time counting.
To start over press RESET to display the preset value again.
When the timer reaches 00:00:00, the timer will stop counting and the audible alarm will sound for 2 seconds.
During a DOWN count elapsed time operation, you can display any of the other time functions using the UP/DOWN/
CLOCK switch as desired
© American Time
© American Time
Timer Control Station (Optional) Operation
9