Dongcheng DJX03-255 Manuale di istruzioni per l'uso - Pagina 7
Sfoglia online o scarica il pdf Manuale di istruzioni per l'uso per Sega Dongcheng DJX03-255. Dongcheng DJX03-255 14. Electric mitre saw
Stampa la pagina
raise the blade and counterclockwise
to lower it. (Fig. 10)
Refer to the following procedures for
the adjustment:
Unplug the tool and lower the handle
completely, use the socket wrench to
turn the adjusting bolt until the
distance between the front face of the
guide fence and the front point where
the blade crossing with the top
surface of the turn base meets 130
mm (5-1/9"). (Fig. 11)
With the tool unplugged, rotate the
blade by hand while holding the
handle all the way down to be sure
that the blade does not contact any
part of the lower base. Re-adjust
slightly, if necessary.
Adjusting the Miter Angle
CAUTION:
Be sure to raise the handle fully
while turning the turn base.
Loosen
the
grip
by
turning
counterclockwise. Turn the turn base
while pressing down the lock lever.
When the grip has been moved to the
it
-11-
position where the pointer points to the desired angle on the miter scale, securely
tighten the grip clockwise. (Fig. 12)
Adjusting the Bevel Angle
CAUTION:
Be sure to raise the handle fully while tilting the saw blade.
The saw blade can be tilted at 45° to the left only when the sub-fence locates at the
left position (refer to the instructions of "Sub-fence").
After changing the bevel angle, always secure the arm by tightening the lever
clockwise.
To adjust the bevel angle, loosen the lever
at the rear of the tool counterclockwise. (Fig.
13)
Push the handle to the left to tilt the saw
blade until the pointer points to the desired
angle on the bevel scale. Then tighten the
lever clockwise firmly to secure the arm.
(Fig. 14)
-12-