American Time SiteSync IQ Manuale di installazione e funzionamento - Pagina 11

Sfoglia online o scarica il pdf Manuale di installazione e funzionamento per Trasmettitore American Time SiteSync IQ. American Time SiteSync IQ 13. Wireless system controller with standard gps & magnetic mount tx antenna
Anche per American Time SiteSync IQ: Manuale di installazione rapida (2 pagine), Manuale di installazione e funzionamento (2 pagine), Manuale di installazione e funzionamento (7 pagine), Manuale di installazione e funzionamento (6 pagine), Manuale di installazione rapida (2 pagine), Manuale di installazione rapida (2 pagine), Manuale di installazione rapida (2 pagine), Manuale di installazione rapida (2 pagine), Manuale di installazione rapida (2 pagine), Manuale di installazione rapida (2 pagine), Manuale di avvio rapido (2 pagine), Manuale di avvio rapido (2 pagine), Manuale di avvio rapido (2 pagine)

SiteSync IQ Wireless Controller

Installation Manual

Wired Signal Circuit Installation

To install wired signal circuits (for electrical device control including bells, tone generators, lights, etc.):

1. Disconnect and lock out power to the SiteSync IQ Wireless Controller and any circuit wiring.

2. Remove the cover from the Wireless Controller.

a. Remove 2 screws from each side of the wire compartment cover.

b. Remove the wire compartment cover

3. Route signal circuit wires into the wiring compartment of the Wireless Controller.

a. Remove knockout(s) below wire compartment.

b. Use copper conductors only.

c. Use strain relief connector fittings in the knockout holes to secure the wires.

d. Route the wires into the wiring compartment, leaving enough slack to make all connections to the relay terminals.

4. Connect signal wires to the circuit relay terminals.

a. Route the power (feed) line of each circuit to the COM terminal of the desired circuit (1-6) being connected.

b. Route the switched (load) line of each circuit to the NO terminal of the desired circuit (1-6) being connected.

c. Label the wires for each circuit as desired.

5. Replace the wire compartment cover.

The signal circuits are protected with surge suppression components. In some applications, this protection can cause

Note:

leakage current to trigger the output device(s) when the circuit is switched OFF. In these cases, the surge protection switches can

be moved to the OFF position. Contact American Time Technical Support with any questions at 800-328-8996.

6. Apply power to the Wireless Controller and signal circuit(s).

7. Test the signal circuits using the Sitesync IQ System Controller circuit menu or Remote Connect circuit tab.

Appendix B: Relay Wiring Diagram

COM

BELL 1

BELL 2

BELL 3

BLACK

FUSED

POWER

SOURCE

WHITE

Example

COM

BELL 4

BELL 5/CLK A

BELL 6/CLK B

See larger clock relay

detail on Page 12