Astivita OVEN90M Manuale di istruzioni per l'uso - Pagina 15

Sfoglia online o scarica il pdf Manuale di istruzioni per l'uso per Forno Astivita OVEN90M. Astivita OVEN90M 20. Multifunction electric oven

5.6 Changing the light bulb

CAUTION!

•

WARNING: Ensure that the appliance is switched off before replacing the lamp to avoid the possibility of

electric shock.

•

Wear protective gloves to change the light bulb.

•

To make the replacement, proceed as follows:

•

Disconnect the power supply from the power socket or switch off the circuit breaker of the unit's power

socket.

•

Unscrew the glass lamp cover anticlockwise (note that it might be stiff) and change the light bulb with a

new one of the same type.

•

Screw the glass lamp cover back into place.

•

NOTE: Use only halogen lamps 25 W / 230 V, T300°C.

5.7 Disassembly of convection motor.

WARNING: Turn off the electrical power supply to the

appliance prior to servicing it. Failure to disconnect the power

supply during service may result in an electrical shock or fire

hazard.

Step 1: Use a screwdriver to remove the screws on the back

of the cavity inside to disassemble the convection motor

cover, and then pull it out from the clipping hole.

Step 2: To reassemble the convection motor cover, perform

the operations described above in reverse

6. TROUBLESHOOTING

CAUTION!

11.1 What to do if...

Problem

The oven fails to heat.

Refer to the chapters on safety.

Cause Possible

The oven is off.

The end of cooking is on position "0"

You have not selected the required settings.

CLIPPING

SCREW

Solution

Switch on the oven.

Position the End of Cooking on manual

Check that all the settings are correct.