Donovan Hammer II Manuale d'uso - Pagina 13

Sfoglia online o scarica il pdf Manuale d'uso per Apparecchiature industriali Donovan Hammer II. Donovan Hammer II 20. Arm system for belly dumps, end dumps, dump bodies & pups

Stampa la pagina

P/N 1809533 Rev. B

STEP 5: Lay front edge of tarp across tarp axle and center

tarp with box (cab guard may be off center). Start at

center and work toward edges, pulling tarp tight.

Option 1 (Recommended) - Thread front of tarp with plastic

rod into slot in center of roller bar. Trim ends of rod to fit tarp.

plastic rod on

front of tarp

slot in roller bar

Option 2 - Fasten screws

through washers and grom-

mets into threaded groove.

Hardware not included.

option

screw

washer

tarp

grommet

Option 3 - Install nuts into axle

groove, fasten screws through

washers, grommets and nuts.

Hardware not included.

option

screw

washer

tarp

grommet

nut

Tarp must wind open in direction

shown. To prevent debris from

entering tarp axle, position tarp

to roll open off top of axle toward

rear of box.

Tarp Tube Assembly & Tarp Installation - continued

STEP 6: Position tarp arms at top rear of box. Square up tarp

tube with box by adjusting distance where tarp tube

enters arms.

NOTE: First, insert tarp tube as far as possible into tarp arms.

Pull ends of tarp tube slightly out of each arm as needed to

align tarp tube squarely across box.

STEP 7: Drill 5/16" hole through both arms approximately 3"

lower on lower arm. Attach with cap screw

washer

NOTE: Maintain minimum 18" inset when cutting upper arm

down to length.

5/16"

drill

tarp arm

and lock nut

hole

18"

tarp tube

rear

of box

, flat