Donovan Sidewinder Manuale d'uso - Pagina 8

Sfoglia online o scarica il pdf Manuale d'uso per Ricambi per camion Donovan Sidewinder. Donovan Sidewinder 16. Electric side-flip tarp system

Stampa la pagina

Lid Installation

STEP 1: Install roller and shaft onto actuator arm using c-clip
and shim.
NOTE: This may slide as needed through actuator arm in
order to line up with front lid roller track.
SHIM
C-CLIP
ACTUATOR
STEP 2: With actuator arm near fully open position, slide front
lid roller track over roller and pivot into alignment. Attach to hing-
es with bolts
, washers,
F
F
STEP 3: Install spacer
into roller track using bolt
M
M
and lock nut
.
J
J
G
G
G
DONOVAN
8
ROLLER
SHAFT
and lock nuts
.
K
K
H
H
H
K
K
F
C
C
J
C
M
J
®
STEP 4: Repeat Step 2 for center and rear lids using two and
four bolts respectively to connect to their hinges.
STEP 5: With all three lids in closed position, measure distance
between lids and add 8" to get the final length of each ladder
section.
STEP 6: Assemble two to three ladder sections and "H" con-
nectors to obtain final length of front lid from previous step. If
needed, cut ladder to length. Ensure cut is at least 4" (101.6mm)
away from nearest rung so there is enough remaining to insert
into lids.
LADDER SECTION
STEP 7: Mark ladder 4" (101.6mm) in on each end. Lift and
slide front ladder section into front and center lids until each
, washers
has been inserted a minimum of 4". Weld all four sides of each
ladder to front and center lids. Note underside will be welded in
Step 8.
STEP 8: Repeat process for rear ladder using final length for
the rear ladder from Step 5. Open system to access underside
of ladder to finish welding.
HELP LINE: 1-800-327-8287
FRONT
LADDER
MEASURED
MEASURED
+8" =
+8" =
"H" CONNECTOR
WELD (4) SIDES
4" INSERTED
4" INSERTED
WELD (4) SIDES
FINAL LENGTH FROM STEP 2
WELD (4) SIDES
4"
P/N 1809453 Rev. A
REAR
LADDER
LADDER SECTION