Astonica 50105082 Istruzioni per il montaggio - Pagina 2

Sfoglia online o scarica il pdf Istruzioni per il montaggio per Arredamento per interni Astonica 50105082. Astonica 50105082 2. Naples patio table

Stampa la pagina
PARTS & HARDWARE LIST
PART #
DESCRIPTION
A
Glass Tabletop
Legs
B
C
Connector Ring
Screws
D
E
Washer
F
Plastic Hex Screw Covers
Umbrella Sleeve with Cap
G
H
Hex Driver
Carefully remove the contents from the package.
If any parts are missing do not attempt to use the product until they have
been obtained and correctly installed.
IF YOU HAVE ANY PROBLEMS OR QUESTIONS CONCERNING THIS PRODUCT,
DO NOT RETURN IT TO YOUR RETAILER. CONTACT CUSTOMER SERVICE AT
1-888-424-3354.
A
E
F
CARE and MAINTENANCE
CLEANING: Use a mild detergent and warm water on the frames.
Do not use abrasive materials or cleaners. Commercial glass cleaner may be used
on the glass top.
MAINTENANCE: Glossy finishes may be maintained by using a quality auto wax
twice a year. Sanded or textured finishes should not be waxed. When ready to
store your table, be sure no water has accumulated in the frame. This will
prevent damage due to freezing temperatures.
WARNING: DO NOT SIT, CRAWL, WALK OR CLIMB ON YOUR GLASS TOP TABLE.
Tempered glass is engineered to break safely into blunt pieces, but may still
cause injury.
QUANTITY
B
C
G
1
4
1
8
8
8
1
1
A
ASSEMBLY INSTRUCTIONS
1. Place the tabletop (A) upside down on a non-scratching surface.
2. Insert the legs (B) into the sleeves located underneath the tabletop (A) so that the
D
rubber bumpers are next to the glass.
3. Hold the connector ring (C) in the center of the legs (B) and align the two holes in
one leg with two holes in the connector ring (C). Insert (2) screws (D), with
(2) washers (E). Attach the connector ring (C) to the other (3) legs (B) in the same
H
manner.
4. Tighten all of the screws (D) with the hex driver (F) provided.
5. Place (8) plastic hex screws covers (F) into the ends of the bolts.
CAUTION: When using a patio umbrella with your table, make sure the
clear plastic ring is attached to the hole in the center of the table. Place the
umbrella through the opening and into a 50 lb. minimum cast iron steel umbrella
base, or one filled with water or sand. Do not insert the umbrella into the table
without using a base as described above. Umbrellas should be in the down
(closed) position when not in use. Do not leave your umbrella in the up (open)
position during windy conditions.
B
D
F
C E