Astonica 50105348 Manuale di istruzioni - Pagina 2

Sfoglia online o scarica il pdf Manuale di istruzioni per Arredamento per interni Astonica 50105348. Astonica 50105348 2. Kelly resin bistro set

Stampa la pagina
PARTS & HARDWARE LIST
PART #
A
Chair Back
B
Chair Seat
C
Chair leg
D
Chair Center Brace
E
Table Top
F
Table Leg
G
Table Center Brace
H
Small Nut
I
Medium Nut (for chair)
Medium Nut (for table)
J
K
Large Nut
L
Plastic Spanner
A
D
G
H
I
Carefully remove the contents from the package. If any parts are missing do not
attempt to use the product until they have been obtained and correctly installed.
IF YOU HAVE ANY PROBLEMS OR QUESTIONS CONCERNING THIS PRODUCT,
DO NOT RETURN IT TO YOUR RETAILER. CONTACT CUSTOMER SERVICE AT
1-888-424-3354.
NOTE: This product is intended for residential, non-commercial use.
Maximum Load Capacity for chairs is 200 lbs.
DESCRIPTION
C
B
E
L
J
K
1
QUANTITY
CAUTION: Do not over tighten fasteners.
2
1. (SEE FIGURE 1) Insert studs on chair
2
back (A) through holes in chair seat (B).
8
2. With chair back (A) in place, insert
studs of one chair leg (C) into chair
2
seat (B), connecting the chair back,
1
seat and leg.
3
3. Attach two medium nuts (I) and one
large nut (K) using spanner tool (L).
1
4. Attach remaining legs, repeat step 2
11
and step 3.
16
5. Assembly second chair in same manner,
6
repeat steps 1 - 4.
4
1
6. (SEE FIGURE 2) Place threaded studs
of chair brace (D) through the tab
on chair leg (C).
7. Turn the chair upside down.
8. Fasten brace (D) using small nut (H).
Use the spanner tool (L) to tighten
nuts on all four legs. Do not to over
tighten nuts.
F
9. (SEE FIGURE 3) Position table top (E)
upside down on a clean surface.
10. Place the two holes at top of leg (F)
over plastic threaded studs on bottom
of table (E).
11. Secure using medium nuts (J). Use the
plastic spanner (L) to tighten. Do not
over tighten fasteners.
12. Position table right side up.
13. Place threaded studs of table center
brace's (G) through tab on table leg (F).
14. Turn the table upside down and fasten
brace (G) using small nuts (H). Tighten
using spanner (L) on all four legs.
Tighten all fasteners securely. Do not
over tighten the fasteners.
ASSEMBLY INSTRUCTIONS
Figure 1
B
Figure 2
C
Figure 3
K
E
F
2
L
A
C
I
K
I
B
A
L
D
H
C
D
F
L
Plastic
Studs
F
I
G
G