Astonica 40201050 Manuale di istruzioni - Pagina 2

Sfoglia online o scarica il pdf Manuale di istruzioni per Fontana da esterno Astonica 40201050. Astonica 40201050 2.

Stampa la pagina
Astonica 40201050 Manuale di istruzioni
PARTS & HARDWARE LIST
PART #
PART #
DESCRIPTION
A
Base Pedestal
B
Large Basin
C
Center Pedestal
D
Small Basin
E
Electric Pump
Parts Detail
A
C
Carefully remove the contents from the package. If any parts are missing do not
attempt to use the product until they have been obtained and correctly installed.
ASSEMBLY INSTRUCTIONS
1. (SEE FIGURE 1) Place the base pedestal (A) on
flat, level surface. Put the large basin (B) on the
base pedestal (A) aligning the tabs of the basin
with the notches in the top of the base pedestal
(A). Turn the large basin counter clockwise to
lock into place. Put the electric pump (E) into
the center ring in the bottom of large basin (B)
beside the PVC tube. Place the power cord of
the pump (E) through the PVC tube, the pedestal
base (A) and out the bottom of the base
as shown.
2. (SEE FIGURE 2) Put the center pedestal (C) on
the large basin (B).
B
E
D
Figure 1
Power Cord
Power Cord
Power Cord
2
QUANTITY
3. (SEE FIGURE 3) Connect the tube of the small
1
basin (D) to the spout on the electric pump (E).
1
Connect the small basin (D) and center
1
pedestal (C) aligning the tabs of the basin with
the notches in the top of the base. Turn the
1
center pedestal (C) clockwise to lock into place.
1
4. (SEE FIGURE 3) Fill the fountain basin (B) with
water; if possible use distilled water to
fill fountain.
5. Plug power cord into properly grounded
120V AC outlet.
Adjust Speed of Water Flow
1. Unplug pump (E) from AC power outlet.
2. Move adjustment switch on pump (E)
toward "+" positive to increase water
flow, or "-" to decrease water flow.
Maintenance
1. Check water level periodically, add
water if necessary.
2. If water is not flowing, check electric pump (E),
and the clear tubing for clogs.
NOTE: Pump may build up calcium after a
long period of time and stop running when
tap water is used. Any calcium remover can
be used to clean pump.
Outdoor Use Extension Cords
1. When product is used outdoors, use only
extension cords marked for outdoor use.
2. Use only UL listed extension cords. Never use
damaged or altered extension cords.
3. Follow extension cord manufacturer safety
instruction.
Extension Cords
1. Make sure your extension cord is in good condition.
E
2. When using extension cords, be sure to use one heavy enough to carry the current your product
requires. An undersized cord will cause a drop in line voltage resulting in power loss and
B
overheating. Reference Table 1 at the bottom of the page for the correct size to use depending
Basin Tab
on cord length and nameplate Ampere rating. If in doubt, use the next heavier gage. The smaller
the gage number, the heavier the cord.
Base Notch
A
ASSEMBLY INSTRUCTIONS
Table 1. Minimum Recommended Extension Cord Gauge (AWG) Chart
AMP Load
Volts Extension Cord Length
120V
25'
50'
AWG
1-5
18
16
6-10
18
16
10-12
14
14
12-16
14
12
3
Figure 2
C
B
E
Figure 3
D
Tubing
C
E
100'
150'
16
14
14
12
14
12
Not recommended