AmeriGlide Stair Lift Manuale per l'installazione - Pagina 13

Sfoglia online o scarica il pdf Manuale per l'installazione per Sistemi di sollevamento AmeriGlide Stair Lift. AmeriGlide Stair Lift 15. Stair lift

Remove the four screws from the top of

the unit. Set the screws/washers aside.

CAUTION: Be careful not to drop screws/

washers into unit while removing.

Set seat on top of unit chassis. Tip seat

sideways and locate seat control wire.

Plug into the unit seat control wire. Plugs

can only go together one way.

Lower the seat to the unit chassis. Screw

in place with four screws and lock

washers previously set aside. Pull up on

swivel arm to rotate the seat to gain

access to all 4 holes.

If the seat is not level, then you will need

to adjust the seat leveling.

There are 4 hex head screws that hold the

seat level. There are two on the footrest

side of the chassis, and two on the back

side. Loosen all four a couple of turns

(they cannot be taken out).

Firmly level the seat by pushing up on

one arm and down on the other arm, until

the seat is level.

Re-tighten the 4 hex head screws.

NOTE: While these screws are primarily used

to adjust the level of the seat, they also serve

to loosen the chassis so it realigns itself when

needed.

NOTE: The unit is designed so it will not run

unless the seat is facing forward and the

swivel lock is in place.