Doorentryonline 596KP Manuale d'uso - Pagina 2

Sfoglia online o scarica il pdf Manuale d'uso per Tastiera Doorentryonline 596KP. Doorentryonline 596KP 12. 2-wire prestige video system

Programming the 596KP keypad

Basic set up configuration

The manual for the 596KP is quite in-depth so please refer to the basic set-up as written below but also please

read the manual carefully

Both door panel and video monitor have DIP switches to the rear of them which are used for different

configurations, mainly they are used if you have multi door panel installations. If you have the basic system of

1 x door panel and 1 x video monitor then you do not need to worry about the DIP switches at all, they should

all be set to the OFF position

To program the 596KP keypad for basic set up configuration in less than two minutes you will need to enter

the program mode by entering the master default code

The default master code is 1234, so you would press 1234# (1 x hash)

The Red LED will light up to confirm you are now in the programming mode

If you do not press any button for up to 60 seconds the keypad will exit from the programming mode

To manually exit from the programming mode press the * key (1 x star)

To program a user code only – example code 9009

Enter the programming mode by pressing the master code of 1234# (1 x hash)

Press 21# – this is user code position 1

Press 9009# – this is your new user code, if successful the keypad will bleep twice

Press * to exit (1 x star)

Press the user code 9009# to test and the Red LED will light to confirm relay one is activated

To program the lock release timer

Enter the programming mode by pressing the master code of 1234# (1 x hash)

Press 03# then 09# for 9 seconds

Press * to exit (1 x star)

Enter 9009# and the keypad Red LED will light up for 9 seconds

To change the master default code of 1234 to 5678 (or your chosen number)

Enter the programming mode by pressing 1234# (1 x hash)

Press 01#

Press 5678# – this is your new master code, if successful the keypad will bleep

Press * to exit (1 x star)

Important:

do NOT forget your new mater code as you cannot reset the keypad without the master code