Air Doctor AD3000 Manuale d'uso - Pagina 6
Sfoglia online o scarica il pdf Manuale d'uso per Pulitore d'aria Air Doctor AD3000. Air Doctor AD3000 8.
Stampa la pagina
MAINTENANCE
The AirDoctor™ professional air purifier is
almost maintenance free! The high quality
carbon filter lasts up to 6 months and our
Ultra HEPA filter lasts up to 12 months,
depending on use and environment
conditions.
Before replacing the Ultra HEPA or carbon
filter of your AirDoctor™ professional air
purifier, turn off and unplug the unit from
the electrical outlet and read all safety
instructions and important warnings in
this owner's manual.
REPLACING THE ULTRA HEPA
& CARBON FILTERS
1.
Make sure the unit is turned off and
unplugged. With the front of the unit
facing forward, pull the lid towards
you at the upper end as shown and
remove the front cover.
2.
Remove the Ultra HEPA and carbon
filters by lifting and pulling the tabs
on both sides of the filters.
3 . Insert new Ultra HEPA and carbon
filters, then insert the bottom of
the inlet grill first and then snap the
lupper part of the front cover back
into position.
4 . To close the front cover, first make
sure the bottom hooks are properly
in place before snapping it up to its
upright and locked position.
CLEANING THE PRE-FILTER
1.
Make sure the unit is turned off and
unplugged. With the front of the unit
facing forward, pull the lid towards
you at the upper end as shown and
remove the front cover.
2.
Gently remove the pre-filter from
front side of the carbon filter.
3.
To clean the pre-filter, simply
submerge in warm soapy water.
Gently lift and submerge the pre-filter
several times until it is clean.
4.
Rinse the pre-filter with clean water
and allow it to dry completely before
placing it back onto the front side of
carbon filter.
AD3000
1.
2.
3.
4.
8
AD3000
MAINTENANCE
Cleaning the Air Monitor
The Air Doctor™ is designed with an air monitor to
track the quality of your air. Over time the monitor
can become dirty and may require cleaning. The main
symptom of a dirty air monitor is the LED display
remains frozen on one light color. In order to clean
the air monitor you must use a vacuum to clear the
monitor chamber.
1.
Power off and uplug unit.
2.
Locate and open the air sensor panel door
located on the the side of the unit. (Fig. 1)
3.
Use a vacuum cleaner hose to suction any dust
or dirt that may have accumulated inside the
monitor chamber. (Fig. 2)
TROUBLESHOOTING
Before contacting our customer service department, please try the following solutions:
PROBLEM
REASON
Unit won't operate.
1. ON/OFF button hasn't
been pressed.
2. Unit is unplugged.
3. The inlet grill has not been
installed or put back in place
properly.
Reduced air flow or
1. The inlet or outlet grill may
poor filtering.
be blocked.
2. The Ultra HEPA or carbon filter
may be clogged.
3. Filters may still be in bags.
9
Figure 1
Figure 2
SOLUTION
1. Press ON/OFF button.
2. Plug in unit.
3. Check to ensure filters
are properly installed &
the inlet grill is installed
& locked into place. (See
instructions on pg. 8)
1. Ensure nothing is in
front of or on top of the
purifier.
2. Check filters and replace
it if necessary. (See
instructions on pg. 8).
3. Remove filters from
bags.