AmerTac ZH101 Manuale d'uso - Pagina 2

Sfoglia online o scarica il pdf Manuale d'uso per Telecomando AmerTac ZH101. AmerTac ZH101 12. Universal tv remote

Introduction

Your Universal TV Remote controls most all TV brands

presently available.

Battery Saver:

If the remote accidentally gets stuck down the back of

the couch with a button pressed it will stop transmitting

after about 30 seconds so as not to drain the battery.

Code Saver:

When changing batteries have the new batteries handy

before removing the old ones. If the remote has no bat-

teries installed for more than about 10 minutes you will

lose the installed code.

1. Install 2 AAA alkaline batteries in the battery com-

partment on the back of the remote.

2. Look up the 4-digit code for your brand of TV from

the Code Table and install it into the remote.

Direct Library Code Entry

To enter Codes directly from Library Code Table:

1. Press and Hold the Power and Mute buttons simulta-

neously until the red indicator remains on.

2. Release the buttons.

3. Enter the 4-digit Code from the Code List (on page

8) using the CH-, V-, CH+ and V+ buttons. The CH-

button is used for entering the first digit. V- button is

used for entering the second digit. CH+ is used for

entering the third digit and V+ is used for entering

the fourth digit. E.g., for code 0107, do not press

CH-, press V- once, do not press CH+, and finally

press V+ seven times.

4. Press the Mute button to save the code. Note: for a

valid code, the red indicator turns off. For an invalid

code, the red indicator blinks rapidly for three sec-

onds before going off.

5. Direct code entry is now complete.

6. Write your code below in case you forget it: