Ames Instruments 64020 Manuale d'uso e istruzioni di sicurezza - Pagina 4
Sfoglia online o scarica il pdf Manuale d'uso e istruzioni di sicurezza per Strumenti di misura Ames Instruments 64020. Ames Instruments 64020 16. 400a ac digital clamp meter
Stampa la pagina15. People with pacemakers should
consult their physician(s) before
use. Electromagnetic fields in close
proximity to heart pacemaker could
cause pacemaker interference
or pacemaker failure.
16. Do not test voltage on circuits
higher than 600 volts.
17. Do not test current on circuits
higher than 400A.
18. Use as intended only.
19. Prior to testing resistance, diodes,
or continuity; disconnect all power
to the circuit and discharge all
high-voltage capacitors.
20. Dress properly. Protective,
electrically nonconductive
clothes and nonskid footwear are
recommended when working.
21. Wear ANSI-approved safety
goggles during use.
22. Only use accessories intended
for use with this Meter.
23. Performance of this Meter may vary
depending on battery condition.
24. Use the proper settings, terminals,
techniques, and range for the
tests performed. Start with the
range stated in the instructions.
Page 4
SAVE THESE INSTRUCTIONS.
For technical questions, please call 1-888-866-5797.
25. Do not apply voltage to the
Test Leads when the Meter is in
the ohms testing setting. Damage
can occur to the Meter.
26. Do not switch between testing modes
with the Meter connected to a circuit.
27. Do not use the Meter at a setting
marked as blank on the scale.
28. Prior to testing capacitors, resistance,
diodes, or continuity; disconnect all
power to the circuit and discharge
all high-voltage capacitors.
29. Have the Meter calibrated by a
qualified technician every year.
30. Do not disassemble Meter; take
it to a qualified technician when
service or repair is required.
31. The warnings, cautions, and
instructions discussed in this
instruction manual cannot cover all
possible conditions and situations that
may occur. It must be understood
by the operator that common sense
and caution are factors which cannot
be built into this product, but must
be supplied by the operator.
Item 64020