Ames Instruments DM1000 Manuale d'uso - Pagina 13

Sfoglia online o scarica il pdf Manuale d'uso per Strumenti di misura Ames Instruments DM1000. Ames Instruments DM1000 16. Electrician/hvac trms digital multimeter

Stampa la pagina
Ames Instruments DM1000 Manuale d'uso

Capacitance Measurements

Measure capacitance up to 66mF.
WARNING! Turn off all power and fully
discharge capacitors on the circuit
under test before measuring.
1.
Plug black test lead into COM Jack.
Plug red test lead into Input Jack.
2.
Turn the Rotary Switch
to the
position.

Current Measurement

Measure AC and DC conductors
carrying up to 10 amperes.
Note: Amperage is always tested
in series with circuit under test.
Note: When using manual range
mode, always start with the highest
range if the amperage is unknown.
1.
Turn the Rotary Switch to the
,
or
position, depending on the
amperage of the conductor under test.
2.
Always start with the highest range
if the amperage is unknown.
3.
Plug black test lead into COM
Jack. If amperage is < 600mA,
plug red test lead into μAmA Jack.
If amperage is > 600mA, plug
red test lead into 10A Jack.
Item 64019
For technical questions, please call 1-888-866-5797.
3.
Carefully touch capacitor
leads with tips of probes.
4.
Read measured capacitance
on the Display.
5.
When testing is complete, turn
Rotary Switch to OFF, remove
and store capacitor and Meter.
4.
Connect the Test Leads across
the circuit to be measured.
5.
Read measurement. For AC current,
frequency is shown at the top right.
Switch to lower ranges, as necessary,
to get the most accurate reading.
6.
When testing is complete, turn
Rotary Switch to OFF, remove
Test Leads and store with Meter.
Note: If the Display shows OL while in
manual range mode, the measurement
has exceeded the selected range. A
higher range should be selected.
Page 13