Akw M17 DigiPump Istruzioni per l'installazione e la cura dell'utente - Pagina 9
Sfoglia online o scarica il pdf Istruzioni per l'installazione e la cura dell'utente per Prodotto idraulico Akw M17 DigiPump. Akw M17 DigiPump 20. Digipump
Stampa la paginaFitting Flow Sensor(s)
Fitting Flow Sensor(s)
Depending on the installation install 1 or 2 filters and sensors to the shower water feed. Install the filter
(Y-Pattern filter) in the correct flow orientation to the shower water supply line and then fit the flow sensor
between the filter and the shower.
Confirm shower water supply pipework is flushed before connecting to the shower sensor via the filter.
Electric showers have one water supply line, cold water. Fit one Filter and Flow Sensor to this line.
Mixer showers have two supply lines, hot and cold water. Fit one Filter and Flow Sensor to each supply line.
Double check direction of the flow arrow moulded on the sensor casing is in the correct orientation with
the flow of water. Allow enough distance so that the sensors are easily accessible. Ensure all cable
connections are accessible and in a dry location. Fit sensor using an approved liquid based thread sealant
suitable for nylon threads. Connect the sensor tail cable from the flow sensor to the pump sensor cable
(see page 11). Do not tile over the flow sensors and filters and ensure they are accessible for service
and maintenance purposes.
Vertical Water Feed Installation
Vertical Water Feed Installation
Flow
Direction
Flow
Direction
Horizontal Water Feed Installation
Horizontal Water Feed Installation
Filter in wrong orientation
Filter in correct orientation
Filter
Correct orientation
Flow
Sensor
Shower
Sensor
Tail
Flow Sensor check
flow direction
9
Flow Direction
Wrong orientation
Sensor
Pump Sensor Cable
Tail
Flow
Direction
Check flow sensor direction.
Pump Sensor
Cable
Shower