Dor-O-Matic 96000 Series Manuale di istruzioni per l'installazione - Pagina 4

Sfoglia online o scarica il pdf Manuale di istruzioni per l'installazione per Controllore Dor-O-Matic 96000 Series. Dor-O-Matic 96000 Series 7. Slide control

Stampa la pagina

Close doors.

If the 4-position switch is used, be sure it is in the "2-way" position before proceeding.

Apply power to the system using the main power switch on the header/cover.

Apply an activation signal (activate inside or outside motion sensor, press keypad "test activate" or momentarily move the

4-way to the hold position).

Observe sizing cycle. If door slams open or closed, reduce sizing speed (SS) setting. Remove power and repeat steps 3

to 5.

Note: Allow the door to remain at the fully closed position for a minimum of one (1) second to complete the sizing

mode.

Caution: If the door sizing speed is set too fast, blown fuses and/or a tripped circuit breaker may occur if the

doors are activated when manually locked.

After sizing is complete, make adjustments to other settings as needed.

84657-084 REV. B

SETTING

: OPENING SPEED

: AUTO-REVERSE-OPEN

: BACKCHECK POSITION

: BACKCHECK SPEED

: HOLD-OPEN DELAY

: CLOSING SPEED

: AUTO-REVERSE-CLOSE

: LATCH POSITION

: LATCH SPEED

: ENERGY-WISE POSITION

: ELECTRIC LOCK

: SIZING SPEED

: FUNCTION

: STATUS ANNOUNCEMENT

KEYPAD LABEL DRAWING

July 2003

TEST

ACTIVATE

SETTING

VALUE

DEFAULT

DOWN

84725-600 REV. 0

Page 4 of 7