Doran SCC-AM-00 Manuale di installazione e funzionamento - Pagina 10
Sfoglia online o scarica il pdf Manuale di installazione e funzionamento per Strumenti di misura Doran SCC-AM-00. Doran SCC-AM-00 15. Sleeping child check
Stampa la paginathem come on, then the relay in the Sleeping Child Check will ground the
dome lights exactly like the doors. At the input to the SCC FRT DOOR- this
would indicate a door has opened and trip the alarm when the ignition is
turned off. For this condition, it will be necessary to install separate door
switches for the Sleeping Child Check or not use/wire the overhead light
feature.
Figure 3 shows an example of a relay isolated circuit like may be found on some vans.
The polarity fuse position is determined the same way as described for a standard bus,
see A in Interior Overhead Light section above.
V(+) battery
C. CONVERSION VANS / MINI BUSES W/0 WARNING FLASHERS
Use ignition/accessory or brake light input at the ARM terminal P6.
Where driver usually must exit through driver door instead of
A 10 minute ARM timer option may be used with or instead of a
lV. Reset Switch Installation
The Reset switch (Figure 4) included with the Sleeping Child Check will need to be
installed in the rear interior of the school bus. Be sure there is adequate access space
behind the chosen location before installing the switch. An electric drill and 5/8" drill bit
are required for installation.
TO DOME (P3)
FUSE (F3) TO POS +
NC
NO
RELAY
TO SCC (P8)
FRONT DOOR
GND
Example of relay isolated Dome Lights and Door Switches
This usually means the system will need to be reset after any
startup.
passenger door, use end of trip 1 minute timer option as ALARM
delay to allow the driver to reenter vehicle, check that the vehicle is
empty and reset the monitor.
typical ARM signal. For cases / situations where the typical ARM
signal is not available or used, an optional 10 minute timer will ARM
the monitor after 10 minutes with the ignition/accessory on.
DOOR
SWITCHES
GND
FIGURE 3
DOME LIGHTS
GND
9