Astro Pneumatic 600ST8 Manuale - Pagina 3

Sfoglia online o scarica il pdf Manuale per Strumenti Astro Pneumatic 600ST8. Astro Pneumatic 600ST8 10. Straight type punch / flange tool

Stampa la pagina
Astro Pneumatic 600ST8 Manuale
The oil and water extractor should not be mounted on or near the air
compressor.
The temperature of air is greatly increased during compression. As the air
cools down to room temperature, in the air line, on its way to the Air Power
Tool, the moisture contained in it condenses. Thus, for maximum
effectiveness, the oil and water extractor should be mounted at some point
Pitch pipe back toward air receiver
Compressor unit
Drain
Daily
600ST
(5.5mm)
600ST8
(8mm)
SUGGESTED AIR LINE CONNECTION
PIPE SIZE, I.D. (Inches)
Air Flow
Length of Pipe (feet)
CFM
50
10
1/2"
20
3/4"
30
3/4"
40
1"
50
1"
70
1"
Oil and Water Extractor should be at least 25 ft. from the compressor. Further if possible.
STRAIGHT TYPE PUNCH / FLANGE TOOL

PRODUCT INFORMATION:

• Punch designed for easy replacement
• Performs hole punching and panel crimping
• Features a rotating head for convenient use
• Every pull of the lever delivers a single punch or a single
flange crimp with precision control
• Forms an offset crimped edge on sheet metals
for no-bump lap welds
• Lightweight
• Durable construction
• Reduces metal fabrication time in half

SPECIFICATIONS:

600ST
Punch Diameter:
5.5mm (7/32")
Punch Capacity:
1.6mm (1/16")
Crimping Capacity:
1.6mm (1/16")
Piston Stroke:
5/32" (4mm)
Overall Length:
10" (254mm)
Net Weight:
3lbs. (1.36kg)
Air Inlet Thread NPT:
1/4"
Air Hose I.D. Size:
3/8" (10mm)
Avg. Air Consumption:
4cfm
Air Pressure:
90-120psi
in the air supply system where the temperature of the compressed air in the
line is likely to be lowest. Air lines must be properly drained daily. Each low
point in an air line acts as a water trap. Such points should be fitted with an
easily accessible drain. See diagram below. Pitch all air lines back towards
the compressor so that condensed moisture will flow back into the air
receiver where it can be drained off. Drain daily.
Install drain at
each low point
150
200
100
3/4"
3/4"
3/4"
3/4"
3/4"
1"
1"
3/4"
1"
1"
1"
1"
1"
1"
1-1/4"
1-1/4"
1"
25 FEET OR MORE
Page 3
600ST8
8mm (5/16")
1.6mm (1/16")
1.6mm (1/16")
5/32" (4mm)
10" (254mm)
3lbs. (1.36kg)
1/4"
3/8" (10mm)
4cfm
90-120psi
Oil and Water
Extractor
Drain
Daily
Drain
Daily