Flying Lemon cytrynka PDB Manuale d'uso - Pagina 9

Sfoglia online o scarica il pdf Manuale d'uso per Accessori per droni e quadcopter Flying Lemon cytrynka PDB. Flying Lemon cytrynka PDB 20. For power distribution board for zmr/qav/rcx 250 class copters

Stampa la pagina

PORT / CC3D Color

Receiver / White

Receiver / Blue

Receiver / Yellow

Receiver / Green

Receiver / Orange

Receiver / Purple

PORT / CC3D Color

Main and Flexi / Blue

Main and Flexi / Orange

CC3D Conversion Board have default installed 3.3V regulator for Spektrum Satellite

with JST 1.5mm pitch connector, key transistor for buzzer and resistor voltage divider

for battery voltage measurement.

WARNING:

using it with cytrynka PDB you must desolder it. It's not simple. Best

solution is to remove first plastics from pins and after that removing

pins one by one.

Motors wiring with OP and Cleanflight firmware

CL and OP have different motor mixing nonetheless in both firmwares user can define

motors mixing but on CB we added jumpers for define which firmware you using.

CC3D Buzzer usage with Openpilot and Cleanflight

Information about using buzzer with CC3D with OP firmware can be found here:

https://wiki.openpilot.org/display/WIKI/Adding+a+Buzzer+to+Your+Vehicle

Before you must solder jumper "Buzzer off" on CB.

With Cleanflight info about buzzer can be found here:

https://github.com/cleanflight/cleanflight/blob/master/docs/Buzzer.md

Don't solder (or desolder) jumper "Buzzer off" on CB.

Conversion Board Nr / PAD

cppm / 1

ss tx / 2

ss rx / 3

current / 4

vbat/ 5

rssi / 6

Conversion Board PAD

All of CC3D's on market are with soldered PINS. Before

Signal name

PPM

Software serial 1 TX pin

Software serial 1 RX pin

Current measure pin

Battery Voltage sensor

RSSI

Signal name

UART1/3 TX pad

UART1/3 RX pad