COINFYCARE BT001 Manuale - Pagina 4
Sfoglia online o scarica il pdf Manuale per Apparecchiature mediche COINFYCARE BT001. COINFYCARE BT001 8. Electrical beauty table
Stampa la pagina
Installation and use instructions:
Moving and adjusting the table
The casters are controlled by a control rod on both
ends of the table.
● Push the control rod down (it is recommended to
use your feet to push) to activate the casters.
When the casters are on the ground the table is in
a moving status.(Figure 1)
● Push the control rod up (it is recommended to use
your feet) and the casters are in the retracted
status.
When the casters are retracted the table is in a fixed
position.(Figure 1)
Figure 1 Foot pedal position
● Adjustable feet for height adjustment are installed
on the four legs of the table. Every time after moving,
please make sure that the four adjustable feet are in
full contact with the ground, otherwise you should
rotate the adjustable feet to adjust.(Figure 2)
Figure 2 Adjustable feet of the table
Please confirm the table is in its fixed position
before treating the patient. It is strictly forbidden to
use a table in "moving status". The "moving status"
can only be used when moving the table from
place to place.
Every time after moving, please make sure that the
four adjustable feet are in full contact with the ground,
otherwise you should rotate the adjustable feet to
adjust.
If the table is moved without ensuring that the power
cord is entangled, the casters may roll cross the cord,
and the head/foot section and the movable parts may
be squeezed, resulting in some potential safety risks.
After using the device, please make sure the table in
its lowest level position, and adjust the head/waist/tail
sections to its flat position, and then disconnect the
power cord from the socket. Pulling the power cord is
forbidden to prevent damage to the power cord and
raise safety issues. Please DO NOT disassemble or
change any part of the control circuit without
authorization from Coinfycare.
Lifting the table
The height of the table can be adjusted by the
foot switch. Figure 3 shows the appearance of
the foot switch.
Figure 3 Foot switch
The table can be lifted or lowered by the foot
switch. Step on the left or right button of the foot
switch respectively to adjust the height of the
table.
When the required height is reached (Figure 4),
release the button to stop.
Figure 4 Lifting the table
Please make sure that there are no objects in the
space under the table before any operation.
The table should be placed at the lowest level to
reduce the risk of injury caused by the patient
falling off the table when unattended.
Wing armrest installation
Insert the armrest connector into the square
tube and tighten the knob (Figure 5).
Figure 5