Astro Tool M22910/7-1 Manuale di avvio rapido - Pagina 3
Sfoglia online o scarica il pdf Manuale di avvio rapido per Utensile a crimpare Astro Tool M22910/7-1. Astro Tool M22910/7-1 3. Connector assembly tooling cycle controlled c-frame style crimp tool
Stampa la pagina
2. If calibration of the hand pressure is required,
locate the adjustment screw in the Movable Die Nest
by closing the tool. Using a flat blade screwdriver,
rotate the screw to the right to decrease the pressure,
to the left to increase the hand pressure. See figure #
5
3. When hand pressure calibration is achieved,
lock screw in place using an appropriate NON-
PERMANENT sealant.
g. Tool Gaging
1. Astro Tool Corp. manufactures flat GO-NO GO
pin assemblies for many of the dies used by the
612648 crimp tool. Contact the factory for your
specific requirements.
ASTRO TOOL CORP. MANUFACTURERS OF INSTALLING, REMOVAL AND CRIMP TOOLS
21615 S.W. T-V HWY.• BEAVERTON OREGON 97003 • 503-642-9853 • FAX 503-591-7766
Figure #5
CONNECTOR ASSEMBLY TOOLING
GO Pin Inserted
Into Cavity
2. With a die set properly installed, cycle the tool
into the fully closed position. Insert the appropriate
GO sized flat pin into the hex cavity. It shall freely
enter the hex cavity. See figure # 6. Remove the GO
pin and attempt insert the NO-GO pin into the hex
cavity. It should not enter the cavity.
DO NOT CRIMP GAGE, TOOL DAMAGE
WILL RESULT.
3
Figure #6
2-11-93 TI648-93-0