Coldair GCV440 Manuale di istruzioni per l'uso - Pagina 8

Sfoglia online o scarica il pdf Manuale di istruzioni per l'uso per Riscaldatore Coldair GCV440. Coldair GCV440 20. 2300w convector heater with wifi

POWER

Switch the main power button on whichis located on the end of the heater.

After the power is turned on, the computer board emits a 'click' and the screen displays the

current room temperature and the set temperature.

Press the On\Off key once to enter the standby state.

HEAT SETTING

Press the 'Heat Setting' button to adjust the heat setting from 1000W to 1300W to 2300W & ANTI-

FROST.

In anti-frost: If the heater is in standby and the room temperature is lower than 5°C, the heater will

automatically turn on to HIGH heating mode. When the room temperature reaches 9°C, the

heating is turned back to standby. This cycle will repeat as required.

TEMPERATURE

The set temperature is displayed every time the appliance is power up. The temperature can be set

when the appliance is in stand-byor heating.

Press the '+' or '-' buttons to set the desired room temperature.

The temperature range is 5°C-37°C.

The appliance can hold the last temperature setting in its memory. This temperature will be shown

at each start-up.

TIMER

Press the timer button, each time the time is increased by 1 hour up to 24 hours. Once the timer is

set, the timer countdown starts after 5 seconds. When the set time has elapsed, the heater will go

back into standby mode.

To cancel the timer, press the timer button until the display read0h 00m.

Operating your Heater

1. Selected heating level display

2. 'Fan' symbol

3. 'Frost protection' symbol

4. Selected unit of measurement display

5. Fan button

6. Increase temperature

7. Reduce temperature

8. Timer button

9. Running time display

10. Set temperature display

11. Measured temperature display

12. On/Off button

13. Infrared receiver for remote control

14. Wi-Fi button

15. Heat Setting Button

16. Wi-Fi indicator lamp