Coldelite KW-77 Manuale operativo - Pagina 11

Sfoglia online o scarica il pdf Manuale operativo per Distributore di bevande Coldelite KW-77. Coldelite KW-77 15. Counter model whipped topping dispenser

Stampa la pagina

C) Assembling the Front Drip Cup Bracket

Locate the parts needed to assemble the front drip

cup, bracket and hopper plugs. (Refer to figure 7)

Figure 7

Lightly lubricate the orings and install onto the

correct parts. Slide the drip cup holder onto the

metal drip cup-mounting bracket. Install the

metal bracket onto the front retaining screw

located on the lower front panel. While holding

the metal drip cup bracket, install the front drain

plug into the front drain tube of the dispenser.

This drain plug will also hold the front metal

bracket onto the dispenser. Place the drip cup and

cover into the drip cup holder. The front drip cup

is now completely assembled.

Install the inside drain plug (hook) into the mix

storage tank drain hole.

The machine is now completely assembled and

ready to be sanitized and started.

Part V – Sanitizing the Dispenser

The dispenser is now assembled but must be

sanitized prior to filling with fresh mix.

Mix one gallon of sanitizing solution in a clean pail

with warm water (80-90 degrees F). Using the Stera-

Sheen (Green label) or equivalent sanitizer, follow

the manufacturer's directions on the packet to ensure

a 100ppm-solution concentration is achieved.

Pour the sanitizing solution into the mix storage

tank. Using the largest cleaning provided with the

tool kit, brush clean all of the surfaces of the mix

storage tank.

Press the "Power ON" button

on the front touch pad.

Place a container or pail under the dispensing head.

Now press the product dispense button on the front

touch pad. This will run sanitizing solution through

the texturizer tube assembly and dispensing head,

sanitizing all product contact surfaces. Dispense

approximately 6-8 ounces of sanitizing solution, then

release the dispense button.

Press the "Power OFF" button

on the front touch pad, turning

the machine to the off mode.

Allow the remaining sanitizing solution to remain in

the dispenser for 2 – 3 minutes.

To drain the remaining sanitizing solution from the

dispenser, place a pail under the front drain plug next

to the front panel. Remove the front drain plug, then

slowly remove the hook drain plug from inside the

mix tank. The sanitizing solution will now drain

from the dispenser. Using the sanitized spatula

provided in the spare parts kit, direct the remaining

sanitizing solution to the drain hole in the mix tank.

After all of the sanitizing solution has drained from

the dispenser, reinstall the hook drain plug and front

drain plug unto the machine.

You are now ready to fill the dispenser with fresh,

liquid mix.

Part VI – Starting the Dispenser

OFF