Daedalus Sparrow Manuale - Pagina 18

Sfoglia online o scarica il pdf Manuale per Macchina da cucire Daedalus Sparrow. Daedalus Sparrow 20. Spinning wheels

Daedalus Battery

All of our Daedalus e-spinners require 15V power. Our official

Daedalus Battery can change voltage simply by pressing the power

button until 15V appears. The Daedalus Battery uses an 18v 3amp

power supply. Do not swap this power supply with your wheel's power

supply for any reason.

Input (long side of battery) - for charging your battery

Output (short side of battery) - for powering your wheel

Best Practices

• Do not attempt to charge the battery and operate the wheel

at the same time.

• Do not use your wheel's power supply to charge the battery,

and vice versa, do not use the battery's power supply to

power your wheel. Label your cords to avoid a mixup.

• If your e-spinner is going slower/faster than you remember

it spinning at your usual settings, check the battery setting to

ensure that it is still set to 15V.

• The battery will power off if the e-spinner is not drawing

enough power from it. This happens with the Sparrow if the

speed is set too low, and sometimes with the Starling. To

compensate for this, you can use a USB-powered light while

your battery is in use or simply charge your phone using the

USB port.

• To ensure the longest possible life for your Daedalus Battery,

please do not store it fully charged for extended periods of

time. The proper storage charge is between 50% and 75%.