DAEHAN STAR F04 Series Manuale d'uso

Sfoglia online o scarica il pdf Manuale d'uso per Apparecchiature di illuminazione DAEHAN STAR F04 Series. DAEHAN STAR F04 Series 4. Super bright s-led module

Stampa la pagina

User Guide

SPECIFICATIONS

PRECAUTIONS

PREPARATION

STAR RGB C04

ELECTRICAL

Current dissipation : 120mA

Power Consumption : 1.44 W

Operating power : DC 12V

Maximum serial connection : 30 modules

Electronic dimming control supported

PHYSICAL

Use precautions to avoid damages to the product or injuries of users. Any actions against following contents will cause serious

issues such as malfunction, electric shock, or burn.

DC12V

USE DC12V ONLY

AC INPUT

DO NOT USE AC INPUT

Do not cut or rejoion wires while product

is connected wth live power source

Avoid performing installation under rain or

high humidity for outdoor use

Do not use the product under circumstances

listed below

- High temperature spots over 60˚C (140˚F)

- Spots draw extreme moisture or dust

- Spots have corrosive gas or highly effectied

by electromagnetic field

TOOLS REQUIRED

Wire Stripper, Drill, Screw Driver, Wiper

PREPARE CHANNELS

1. Clean moisture and dust inside

1. Wipe out dust, water, and oil inside. 3M tape will come off easily if product is mounted on uncleaned surfaces.

2. Make holes for wires from modules to SMPS.

3. Without bushins, wires will easily be cut and short-circuit will occur.

*Use white paint inside the channels for better reflection

DAEHANTRANS CO.,LTD

#7-11 Songdo-Dong, Yeonsu-Gu, Incheon, Korea

Tel. +82 32 858 0491 Fax. +82 32 832 8421 [email protected] / www.daehantrans.com

THERMAL

Cooling : Ambient air

Maximum operating temperature : 60˚C (140˚F)

Minimum operating temperature : -25˚C (-13˚F)

Maximum storage temperature : 60˚C (140˚F)

Minimum storage temperature : -30 C (-22 F)

IP63

Do not perform actions listed below

Maximum driver quantity per serial

connection is limited. Failure causes overload

of current and damages to the product

Refer to 'WIRE THICKNESS' table to use proper

wire thickness between SMPS and the first

LED module

Failure will cause dimmed output

Cable length between SMPS and the first LED

module is limited. Refer to 'CONNECTION

WITH POWER SUPPLY' on page 2

SUPPLIES REQUIRED

Wire Nuts, Cable Ties, IDC Connectors, VCTF(PLTC) Cable,

(Optional : Silicon and Screws)

2. Make holes

- Alter or modify

- Touch LED lamps with sharp objects

- Put glue or silicon over the LED lamps

3. Use bushing to protect wires