DAEHAN BAR S Series Manuale d'uso - Pagina 2

Sfoglia online o scarica il pdf Manuale d'uso per Luce di lavoro DAEHAN BAR S Series. DAEHAN BAR S Series 4. Super bright s-led module

User Guide

PREPARATION

LAYOUT DENSITY

GUIDELINES

WIRING GUIDE

BAR S Series

TOOLS REQUIRED

Wire Stripper, Drill, Screw Driver, Wiper

PREPARE CHANNELS

1. Clean moisture and dust inside

1. Wipe out dust, water, and oil inside. 3M tape will come off easily if product is mounted on uncleaned surfaces.

2. Make holes for wires from modules to SMPS.

3. Without bushins, wires will easily be cut and short-circuit will occur.

*Use white paint inside the channels for better reflection

Use recommended length for pitch between each module to achieve optimum lighting output while maintaining lowest unit

cost. Failure or misplacing will cause dimmed spots or uneven appearance of light on the surface.

In case of showcase

FRONT VIEW

AC Input

Power Supply

DC Output

DAEHANTRANS CO.,LTD

#7-11 Songdo-Dong, Yeonsu-Gu, Incheon, Korea

Tel. +82 32 858 0491 Fax. +82 32 832 8421 [email protected] / www.daehantrans.com

SUPPLIES REQUIRED

Wire Nuts, Cable Ties, IDC Connectors, VCTF(PLTC) Cable,

(Optional : Silicon and Screws)

2. Make holes

Make sure that each run should have 50 M at max

and should use another run in parallel to connect more

Should use thicker wires which can take larger amount of current

than the amount transmitted from the power supply unit

3. Use bushing to protect wires

SIDE VIEW