Cole Parmer EW-36223-05 Manuale di istruzioni - Pagina 15
Sfoglia online o scarica il pdf Manuale di istruzioni per Controllore Cole Parmer EW-36223-05. Cole Parmer EW-36223-05 20. Heating controller
Stampa la pagina
Reassemble
9.3.5. Position new energy regulator and then fit and tighten the shake proof washer and the
locknut.
9.3.6. Replace the energy regulator control knob ensuring the flat on surface on the energy
9.3.6.
Replace the energy regulator control knob ensuring the flat on surface on the energy
9.3.6.
Replace the energy regulator control knob ensuring the flat on surface on the energy
regulator spindle is aligned.
regulator spindle is aligned.
regulator spindle is aligned.
9.3.7. Replace the base and refit the two fixing screws.
9.3.7.
Replace the base and refit the two fixing screws.
9.3.7.
Replace the base and refit the two fixing screws.
The responsible body shall check the electrical safety of the unit before further
The responsible body shall check the electrical safety of the unit before further use.
The responsible body shall check the electrical safety of the unit before further use.
use.
9.4. Replacing the Neons.
9.4. Replacing the Neons.
9.4.
Replacing the Neons.
9.4.1.
Turn your product off and remove it from the mains supply. Disconnect it from any
9.4.1. Turn your product off and remove it from the mains supply. Disconnect it from any
9.4.1.
Turn your product off and remove it from the mains supply. Disconnect it from any
heating resistive loads such as Heating Mantles, Heating Tapes and Cords.
heating resistive loads such as Heating Mantles, Heating Tapes and Cords.
heating resistive loads such as Heating Mantles, Heating Tapes and Cords.
9.4.2.
Turn the Controller up-side down and remove the two fixing screws retaining the base.
9.4.2.
Turn the Controller up-side down and remove the two fixing screws retaining the base.
9.4.2. Turn the Controller up-side down and remove the two fixing screws retaining the base.
Lift the base off.
Lift the base off.
Lift the base off.
9.4.3.
Disconnect the two wires from the relavent neon.
9.4.3. Disconnect the two wires from the relevant neon.
9.4.3.
Disconnect the two wires from the relavent neon.
9.4.4.
Push the neon out from the inside. Note a slight twisting movement may be
9.4.4.
Push the neon out from the inside. Note a slight twisting movement may be
necessary.
necessary.
9.4.4. Push the neon out from the inside. Note a slight twisting movement may be necessary.
Reassemble.
Reassemble.
Reassemble
9.4.5.
Insert the new neon ensuring the tags align with the untouched neon.
9.4.5.
Insert the new neon ensuring the tags align with the untouched neon.
9.4.5. Insert the new neon ensuring the tags align with the untouched neon.
9.4.6.
Reconnect the tags.
9.4.6.
Reconnect the tags.
9.4.6. Reconnect the tags.
9.4.7.
Replace the base and refit the two securing screws.
9.4.7.
Replace the base and refit the two securing screws.
9.4.7. Replace the base and refit the two securing screws.
The responsible body shall check the electrical safety of the unit before further use.
The responsible body shall check the electrical safety of the unit before further use.
The responsible body shall check the electrical safety of the unit before further
use.
15