Daemyung WEBGATE TDM08-SDI-TX Manuale - Pagina 5

Sfoglia online o scarica il pdf Manuale per Multiplexer Daemyung WEBGATE TDM08-SDI-TX. Daemyung WEBGATE TDM08-SDI-TX 8. Hs video multiplexer

Connection Diagram

1. Connect camera and TDM08-SDI-TX's VIDEO IN using coax cable.

- If non PoC Camera: Supply the individual power to camera. To control the camera's PTZ

and/or OSD, connect the RS485 line between camera and TDM08-SDI-TX.

- If PoC Camera: Don't require any other cables except COAX cable.

(non PoC DVR can use PoC camera because TDM08-SDI-TX is PoC

device.)

2. Connect TDM08-SDI-TX and OPT Receiver using Optic cable (Single

mode, LC Type).

- When you connect the Optic cable to TDM08, connect pushing

enough until you hear the "click" sound.

- Pull the lever on the arrow shown in Figure 1) to tightly lock the cables into connector.

- Please use OPT-RX1-RS485U for non PoC DVR and OPT-RX1-RS485P for PoC DVR.

3. Connect OPT Receiver's COAX output and DVR's video input using COAX cable.

- Usable TDM channels are determined according to DVR models. Please refer the DVR's

manual for DVR's TDM configuration and usage.

- Please connect RS485 lines between non PoC DVR and OPT receiver (OPT-RX1-RS485U)

to control camera (PTZ and/or OSD).

- If PoC DVR: Only coax cable is required to control camera (PTZ and/or OSD).

4. Set the CoC OUT switch as OPT.

5. Check the OPT LINK LED is ON.