Bolton Tools FS-5216 Manuale operativo - Pagina 4

Sfoglia online o scarica il pdf Manuale operativo per Utensile elettrico Bolton Tools FS-5216. Bolton Tools FS-5216 7. 52" sheet metal foot shear

HARD

PLASTIC ABS COMPOUND

5.2 BACK GAUGE ADJUSTMENT

On adjusting back gauge, loosen adjustment knobs, slide angle.

Remove rod forward or backward for scales to read zero on pointers.

Lock bracket again and do further an adjustment with wheel.

Tighten socket screws to lock rods in place.

5.3 BLADE CLEARANCE ADJUSTMENT

To adjust blade clearance, loosen front screws and table lock screws,

and loosen table bolts on both sides.

Use a 0.002"slim gauge and adjust table lock screws. Then, tighten

all screws. (See Figure 1).

5.4 CUTTER HEAD ADJUSTMENT

If cutter head is bowed after use. You can adjust the bow bolt. Check

for looseness of mounting bolt. Re-tighten all bolts. (See Figure 2).

To adjust the blade up or down. Drop pin on treadle and loosen nut.

Adjust yoke up or down. Reassemble them.

Loose lock screws may cause shake of blade in operation.

Check and sure they are rightly against shims. But be careful not to

dimple them.

5.5 TO SHARPEN THE BLADE

The upper blade has two cutting edges what are ground with a 2 edges

1.1mm

1.8mm

1.6mm

2.5mm