Dormakaba LA GARD 5715 Istruzioni per l'uso dell'utente
Sfoglia online o scarica il pdf Istruzioni per l'uso dell'utente per Sistema interfonico Dormakaba LA GARD 5715. Dormakaba LA GARD 5715 2. Electronic entry device
Anche per Dormakaba LA GARD 5715: Istruzioni per l'uso dell'utente (2 pagine)
Stampa la pagina
Keypads models 5715, 5750,5750-K are compatible with 4200 (solenoid) and 4200M (motor), 3800/3801/3802/3803 Firmware, 4300 (solenoid) and 4300M (motor),
3800/3801/3802/3803 Firmware, 6040 (solenoid) and 6040M (motor) High Security electronic locks. The eKEY
OPENING THE LOCK
1. Enter valid combination (insert eKEY, if set up, then remove key).
2. The lock will confirm a valid combination entry with a double signal.
3. Within four (4) seconds, turn the keypad to the open position (clock-wise) if using a deadbolt style lock, or turn the handle to the open
position if using a swingbolt style lock.
4. Pull door open.
• Invalid Combination Entry - Lock will signal three (3) times.
IMPORTANT NOTE: Change the combination before putting the lock into operation.
IMPORTANT NOTE: Keep eKEY and combinations secure and separated from each other to minimize opportunity of compromise and/or
security breach.
WRONG TRY PENALTY
• Entry of four (4) consecutive invalid combinations starts a five (5) minute delay period.
- LED flashes red at ten (10) second intervals.
• At the end of the delay period, two (2) more consecutive invalid combinations will restart the five (5) minute delay period.
During delay period, any keystroke will give three audio and visual signals.
CHANGING YOUR COMBINATION
IMPORTANT NOTE: When using eKEY in initialization and combination change, this must be performed by an authorized person in a secure
environment.
1. Enter existing combination and hold down last digit until unit double signals and LED stays on. Observe that the unit will double signal
indicating a correct combination is entered, and then, as the last digit is held down, it will double signal 2-4 seconds later and the LED will
remain on indicating the unit is now ready to receive change commands.
If eKEY is enabled, the eKEY behaves as if it were the last digit in a combination. So, if eKEY is enabled, enter existing combination and
insert eKEY. The unit will double signal indicating a correct combination + eKEY is entered, and then, as the eKEY remains inserted, the unit
will double signal 2-4 seconds later and the LED will remain on indicating the unit is now ready to receive change commands. Then REMOVE
eKEY to proceed.]
WARNING: The port for the eKEY is a data port only. Connecting power to this port will damage the system.
IMPORTANT NOTE: Never use this electronic token in applications other than this HSL Model.
(P/N) 7032.0316 Rev A 02/17 • © copyright 2017
LA GARD 5750-K
ELECTRONIC ENTRY DEVICE
USER OPERATING INSTRUCTIONS
FEATURES
See Manager Instructions for additional features.
USER COMBINATION
• Open Lock
• Change Combination
KEYPAD BACKLIGHTING
• Press either lightbulb icon to illuminate panel keys
EKEY AND AUDITING CAPABILITY
• eKEY is a 48 bit encrypted unique serialized dual token device
• AuditGard auditing software, AuditView or LGView, and a LA GARD interface Adapter are
required.
WRONG TRY PENALTY
• Four (4) consecutive invalid combination initiates five (5) minute delay period.
LOW BATTERY WARNING
• Repeated LED flashing and beeping during opening indicates battery is low and needs
immediate replacement.
AUDIO AND VISUAL SIGNAL
• Double signal - two (2) LED flashes and two (2) beeps - indicates entry is valid or accepted.
• Triple signal - three (3) LED flashes and three (3) beeps - indicates invalid or not accepted.
function is not verified by UL.
II
Kaba Mas LLC
Page 1 of 2