CANTO USA Astro 250 Manuale di istruzioni per l'uso - Pagina 6

Sfoglia online o scarica il pdf Manuale di istruzioni per l'uso per Apparecchiature di illuminazione CANTO USA Astro 250. CANTO USA Astro 250 20.

Followspot Operating Instructions

8. WIRING:

Before being connected to power, please make sure that the unit is outfitted with a suitable plug. Make sure the plug conforms

to the lamp power load. This fixture must be grounded. Ensure the plug conforms to the relevant local safety requirement and

UL electrical standards.

To perform a correct wiring, please note that the cores in this mains lead are color-coded as follows:

Ground: green+yellow – Neutral: blue - Hot: brown

In case the colors of the wires do not correspond to the color of the connection points on your plug, please proceed as follows:

•

The green or green and yellow wire is ground and must be connected to the connection point marked with the

letter E or with the symbol

•

The blue wire is neutral and must be connected to the connection point marked with the letter N or with the

symbol

or colored in black

•

The brown wire is hot and must be connected to the connection point marked with the letter L or with the

symbol

or colored in red

Before you finally position this product for use, temporarily connect it to a properly fused power supply to check the lamp

works correctly.

Before operating this unit please refer to the product label mounted at the back of the luminaire to

check you are operating with the correct voltage.

The Astro 250 LED and 600 LED can be operated between 120V and 208 V.

OPERATION: LCD display for DMX address, system setup and status details.

POWER: power LED status indicator , red color. ON= power

DMX: DMX LED status indicator, green color. LED OFF = DMX OFF and manual control activated ,

LED ON = DMX MODE activated with no DMX signal, FLASHING LED = receiving DMX

MENU: rotary switch selector to select and modify the operational modes.

Turn left or right to navigate through the menu and press to select or to confirm

DMX IN: input DMX signal (pin1=0 , pin2= DATA- , pin3=DATA+ ).

DMX OUT : Loop through DMX signal output

POWER IN: Mains power input

POWER OUT: Mains power output

1092 West Atlanta Street, SE • Suite 600 • Marietta, GA 30060 • 888-252-5912 • [email protected] • cantousa.com

V 1.0 4/19/22

or colored in green or in green+yellow

Innovative Lighting Products