Advance acoustic SC900 Linee guida operative
Sfoglia online o scarica il pdf Linee guida operative per Scrubber Advance acoustic SC900. Advance acoustic SC900 2. 1 scrub system-cylindrical
Stampa la pagina
ATTENTION! Do not use the machine before you have read and understood the Instructions for Use Manual.
1. Turn the machine on and check the
2. Inspect the pads or brushes for wear
status of the batteries. If two bars
or less are showing, charge the
machine for 2 to 8 hours.
6. Press the yellow palm switches on
7. Press the yellow palm switch on the
the front of the handle to transport
the machine to an area for cleaning.
11. Propel the machine forward using
12. When the vacuum motor changes
the yellow palm switches.
16. Rinse the recovery tank and leave
17. Empty the clean water
the lid open to dry. Inspect the
float ball cage.
If the machine has been used until the low battery level indicator is on the machine, a full recharge of the batteries (10-12 hours) will be required. Failure to carry out this procedure may cause damage
to the batteries. Charging the batteries after every use is recommended.
PLEASE ENSURE THE CHARGER IS ALWAYS CONNECTED TO THE BATTERIES EVEN IF NOT USED FOR LONGER PERIOD OF TIME TO PREVENT DAMAGE TO THE BATTERY DUE TO LOW VOLTAGE.
9435 Winnetka Avenue North
240 Superior Boulevard
Brooklyn Park, MN 55445
Mississauga, Ontario, Canada L5T 2L2
www.advance-us.com
www.nilfisk-advance.ca
Phone 800-850-5559
Phone 800-668-8400
Fax 800-989-6566
Fax 800-263-5111
3. Check the squeegee blades for wear
and install them on the machine. Lift
and flip or replace if worn, nicked
the lugs into the slots and rotate the
or torn. Install squeegee and hand
brushes to lock them into place.
tighten thumb nuts.
8. Lower the scrub deck to the floor
back of the handle to go in reverse.
using the foot pedal. Select low,
medium or high scrub pressure.
13. Inspect and clean the debris catch
pitch the recovery tank is full and
needs to be emptied. Refill the
clean water tank as required.
18. Charge the machine for 8 hours.
solution tank.
OPERATING GUIDELINES
SC900
™
4. Inspect and clean the solution filter
as required.
Filter – pn 56104351
9. Lower the squeegee to the floor
and the vacuum motor will start.
14. When finished using the machine,
cage. Refill the clean water tank
remove the pads or brushes.
as required.
Inspect and clean or replace them
as required.
5. Fill the tank with the appropriate
cleaning solution.
Yellow Cap – pn 56115395
10. Select the desired solution flow rate
based on the soil conditions.
15. Clean and inspect the squeegee
blades. Flip the blade or replace it
if required. Hang the squeegee on
the machine as shown.
Tan Gum Rubber Blades – pn 56115334
Red Linatex Blades – pn 56115333