Advance acoustic Carpetwin 56704200 Manuale dell'operatore - Pagina 10

Sfoglia online o scarica il pdf Manuale dell'operatore per Aspirapolvere Advance acoustic Carpetwin 56704200. Advance acoustic Carpetwin 56704200 17.

Stampa la pagina

CLEANING THE VACUUM INLET FILTER

The vacuum inlet filter catches any dirt spilled from the bag, before it can
enter the vacuum motor. The filter is located just below the bag. Clean
the filter every third time that the bag is changed (more often in very dusty
applications). To clean the Vacuum Inlet Filter...
1
Push the Bag Housing Latch (16) in and remove the back cover.
2
Slide the Filter Holder out of the bottom of the Bag Housing.
3
Remove the filter and wash it in warm water. Let the filter dry
completely before putting it back into the machine.
IMPORTANT !
Never operate the machine without the Vacuum Inlet Filter in
place.
D-CHANGING THE ELECTROSTAT EXHAUST FILTER
The electrostat exhaust filter catches any dirt that may escape from the
dust bag, vacuum inlet filter, or lower motor filter. The electrostat exhaust
filter is located just below the carrying handle. Replace the filter every
fifth time that the dust bag is changed (more often in very dusty
applications).
To replace the Electrostat Exhaust Filter...
1
Push the Filter Cover Latch (19) in and remove the Electrostat
Exhaust Filter Cover (18).
2
Remove the Filter from the filter holder and insert a new filter in its
place.
3
Snap the Filter Cover back into place.
IMPORTANT !
Never operate the machine without the Electrostat Exhaust Filter
in place.
TECHNICAL SPECIFICATIONS (as installed and tested on the unit)
Model
Voltage
Rated Power
Protection Class (electrical)
Sound Pressure Level
Total Weight
Vibrations at the Hand Controls
9 - FORM NO. 56041453 / CARPETWIN 14 / 18

CHANGING THE BRUSH

1
2
3
4
5
6

REPLACING THE BELT

To reduce the risk of electric shock, unplug before servicing.
1
2
3
4
5
Carpetwin 14
V/Hz
W
dB(A)/20µPa
lbs / kg
m/s
2
Lay the machine over onto its left side.
Slide the side cover (item #46 / page 13) off of the brush housing.
Carefully pry the roller support (item #40 / page 13) off the end of
the brush (reuse on new brush).
Grasp the center of the brush by the bristles and pull it up and out
the right side of the housing.
Slide brush end with hex opening into housing first, make sure it
slides all the way down onto transmission support (item #34 / page
13).
Follow steps 1-3 in reverse order to reassemble.
WARNING !
Remove screws (7 on Carpetwin 14 / 9 on Carpetwin 18) from the
top cover (item #2 / page 13) and remove top cover from the brush
housing.
Remove both screws in transmission support (item #34 / page 13).
Lift the end of the brush up and remove the belt from the brush
pulley.
Bend brush housing out just enough to slide the belt off of the motor
pulley (be careful not to break housing!).
Reassemble in reverse order.
Carpetwin 18
120/60
120/60
900
920
69
69
19.5 / 8.8
20.5 / 9.3
<2.5m/s
2
<2.5m/s
2