Dot Origin VTAP100-USB Manuale di installazione - Pagina 8

Sfoglia online o scarica il pdf Manuale di installazione per Hardware di rete Dot Origin VTAP100-USB. Dot Origin VTAP100-USB 14.

Example: Changes to config.txt to interact with particular NFC mobile passes

!VTAPconfig

VAS1MerchantID

VAS1KeySlot=2

; This entry will trigger full Apple VAS. When a corresponding pass is

; detected on an Apple iPhone, that pass will be read and decrypted using

; key file 2.

VAS1MerchantURL

; A website URL to be visited when a pass of type # is presented.

; Not currently supported by iOS for VAS-only transactions.

T1CollectorID=97598013

ST1KeySlot=4

ST1KeyVersion=10

; This entry will trigger a Smart Tap interaction. When a corresponding

; pass is detected on an Android phone, that pass will be read and

; decrypted using key file 4, at key version 10.

Note: If a VAS#KeySlot or ST#KeySlot is omitted, or set to 0, then authentication (on

Google Pay Smart Tap only) and decryption (on Google Pay Smart Tap and Apple VAS) will not be

performed. In this case, Apple VAS data will be received by the VTAP100, the phone will register a

pass read, but that data will not be decrypted or output. However, Google Pay Smart Tap data will

be received and forwarded by the VTAP100, but only if the pass does not require authentication

by the terminal.

2.3 Check status in BOOT.TXT

If you navigate to the VTAP100 in the computer's file system. It will appear as an attached mass

storage device and list the files contained, including the BOOT.TXT file.

Inspecting BOOT.TXT will give you essential information about your VTAP100 set up, which might

be helpful when troubleshooting.

You are most likely to need:

VTAP100-USB INSTALLATION GUIDE

Figure 2-1 Example BOOT.TXT file

PAGE 4